Wohler HF 300 Moisture Meter User Manual
- June 4, 2024
- WOHLER
Table of Contents
- Wohler HF 300 Moisture Meter General Information
- Technical Data
- Design and function
- Safety information
- Measuring Method
- Changing the batteries
- Replacing the pins
- Warranty and Service
- Accessories
- Declaration of conformity
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Wohler HF 300 Moisture Meter General Information
Operation Manual In-formation
This operation manual allows you to work safely with the Wöhler HF 300
Moisture Meter. Please keep this manual for your information.
The Wöhler HF 300 Moisture Meter should be employed by professionals for its
intended use only.
Liability is void for any damages caused by not following this manual.
Notes
WARNING!
Not following this warning can cause injury or death.
ATTENTION!
Not following this note can cause permanent damage to the device.
NOTE!
Useful information
Intended Use
The meter measures the relative humidity of wood.
Do not use the meter for any other use than set out in this manual.
Scope of supply
Device | Scope of supply |
---|---|
Wöhler HF 300 | Moisture Meter with |
protective cap
Protective bag
9 V battery
Replacement pins
Information on disposal
Electronic equipment does not belong to domestic waste, but must be disposed
of in accordance with the applicable statutory provisions.
You may hand in any defective batteries taken out of the unit to our company
as well as to recycling places of public disposal systems or to selling points
of new batteries or storage batteries.
Address
Wöhler Technik GmbH Wöhler-Platz 1 33181 Bad Wünnenberg
Tel.: +49 2953 73-100
Fax: +49 2953 73-250
E-Mail: info@woehler.com
Technical Data
Description | Data |
---|---|
Range | 5% to 40 % of wood |
moisture
Resolution| 1% of wood moisture
Precision in considera-
tion of VDI 4206 page 4
| ± 40% of the reference
wood value
Power| 9 V battery
Ambient temperature| +5 °C to 40 °C
Rel. Ambient Humidity| 0 to 70 % rH
Needle length| 12 mm
Dimensions| 129 x 63 x 32 mm
Weight| 116 g (including bat-
tery)
Design and function
Explanation
- Protective cap
- Pins
- HOLD-key
- ON/OFF-key
- LCD Screen
- Battery compartment
Safety information
Avoid possible damage to property or injury to people
WARNING!
The danger of injury because of sharp pins Take care when handling with the
pins! Always put the protective cap on the pins before storing.
Avoid possible damage to the meter
ATTENTION!
Attention must be paid to preventing moisture and dust during application.
Always keep it dry and clean to ensure measurement accuracy.
ATTENTION!
The place where the meter is kept must be clean, the ambient temperature 0 – 40 °C.
Measuring Method
Open
- Pull off the protective cap with two fingers.
Switching on
- Press the ON/OFF key to switch on the meter.
Measuring Method
- Insert the pins of the Wöhler HF 300 into the wood approx. 5 mm.
The meter will display the relative humidity of the wood on the LCD.
Hold the current value
- Press the HOLD-key to hold the current value.An H-Icon on the LCD shows that a frozen value is shown instead of the current value.
- Press the HOLD-key again to bring up the measuring menu again.
Evaluate the measurement result
The user can estimate the combustibility of the measured wood based on the
measurement result according to the three traffic-light colors under the LCD.
green: standard flammable
yellow: hardly flammable
red: combustion not recommended, because too humid
Finishing the measurement
- Press the ON/OFF key to switch on the meter.
- Put the protective cap on the meter.
Changing the batteries
When battery voltage gets low, a low battery indicator will appear on the LCD.
In this case change the batteries as follows:
- Open the battery compartment on the back of the unit.
- Replace the battery by a new 9V battery
Replacing the pins
Broken or damaged pins can be exchanged by the pin-kit.
- Loosen the damaged pins with an appropriate tool (gripper, screw wrench or ring wrench).
- Replace the damaged needles by the needle kit and fix the new needles with the tool.
Warranty and Service
Each Wöhler HF 300 Moisture Meter will be tested in all functions and will
leave our factory only after extensive quality control testing.
If used properly, the warranty period for the Wöh-ler HF 300 will be twelve
months from the date of sale. Electrodes and Batteries are not covered by this
warranty.
This warranty does not cover the freight and packing costs when the device is
sent to the factory for repair.
Service by non-authorized personnel or making modifications to the analyzer
voids any warranty.
Wöhler has built our reputation on excellence in customer service. Therefore,
of course, we are readily available to assist you after the warranty period
ends.
- Send us the device and we will repair it and return it to you with our package service.
- Immediate help is provided by our technical staff over the telephone.
Accessories
6 pairs of replacement pins
Declaration of conformity
The product Wöhler HF 300 complies with the key safety requirements set down
in the guidelines of the Council for the Harmonization of the Legal
Requirements of the Mem-ber States in relation to electromagnetic
compatibility (2014/30/EU).
The following standards were availed of to evaluate the product in respect of
the electromagnetic compatibility:
EN 61326-1:2013, EN 61326-2-2:2013
EN61000-4-2:2009, EN61000-4-3:2006 + A1:2008 + A2:2010
Bad Wünnenberg, 04.08.2022 Dr. Stephan Ester, Geschäftsführer/Managing
Director
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>