NXP FRDM-K32L2B3 Freedom Development Board User Guide
- June 6, 2024
- NXP
Table of Contents
QUICKSTART GUIDE
FREEDOM DEVELOPMENT PLATFORM
FRDM-K32L2B3
GET TO KNOW THE FRDM-K32L2B3
Figure 1: FRDM-K32L2B3 Callouts| Figure 2: FRDM-K32L2B3 Pin-Outs
HOW TO GET STARTED
- Connect the FRDM-K32L2B3 development board to a PC using the included micro-USB cable to the Power/OpenSDA Micro USB connector (J13).
- When the board is powered up, a green LED (D8) will illuminate, indicating 3.3V is on. Notice that Boot ROM code is executed first out of reset, a time of about three seconds are consumed by ROM bootloader to check the active communication port before application code is executed.
- The FRDM-K32L2B3 board comes preprogrammed with a demo that will initiate the LED on the board to flash periodically when plugged in.
- J10 is the USB connector of the K32L2B3 on-chip USB module.
- J14 is the K20 JTAG header for OpenSDA firmware update.
- J11 is the SWD header for K32L2B3.
- Explore more out-of-box demos and download software and tools at www.nxp.com/FRDM-K32L2B3.
GET STARTED
Download installation software and documentation under “Jump Start Your
Design” at www.nxp.com/FRDM-K32L2B3
SUPPORT
Visit www.nxp.com/support for a list of phone
numbers within your region.
WARRANTY
Visit www.nxp.com/warranty for complete
warranty information.
www.nxp.com
NXP and the NXP logo are trademarks of NXP B.V. All other product or service
names are the property of their respective owners. © 2021 NXP B.V.
Document Number: FRDMK32L2B3QSG REV 1
Agile Number: 926-46355 REV B
References
- FRDM-K32L2B3 Platform|Freedom Development Board|NXP | NXP Semiconductors
- Support | NXP Semiconductors
- Returns and Warranty Information | NXP Semiconductors
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>