OLIGHT ‎i3T EOS Ti Titanium 180 Lumen LED Flashlight User Manual

: June 6, 2024
: OLIGHT

Table of Contents

IN THE BOX
SPECIFICATIONS
INSULATING FILM
BATTERY INSTALLATION
AVAILABLE BATTERIES
WARRANTY
Customer Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

OLIGHT ‎i3T EOS Ti Titanium 180 Lumen LED Flashlight User Manual

Thank you for purchasing this Olight product. Please read this manual carefully before use and keep it for future reference!

IN THE BOX

i3T EOS Ti
1*AAA Alkaline battery(installed inside the flashlight)

SPECIFICATIONS

|

---|---|---|---
HIGH| 180lumens| 60m| 21min
LOW| 5lumens| 12m| 16h

|

900CD| 1.5M| IPX8| 60M
LENGTH| 89mm / 3.5in
BEZEL DIAM| 15mm / 0.59in
WEIGHT| 52g / 1.83oz (Including battery)

*All above specifications are test results based on ANSI/NEMA FL1-2009 Standards.

INSULATING FILM

Before first use, unscrew the tailcap and remove the insulating film.

BATTERY INSTALLATION

If the battery needs to be replaced, make sure that the positive end of the new battery faces the flashlight head when you put it in.
BATTERY INSTALLATION

AVAILABLE BATTERIES

1 x 1.5V AAA alkaline battery (included)
1 x AAA lithium battery
1 x AAA NiMH battery

DANGER

DO NOT shine the light directly into human eyes. This may cause temporary blindness, or permanent damage to the eyes.
DO NOT cover the light head when the flashlight is on, or place the flashlight head on the ground. The radiation energy of the flashlight may cause damage to the flashlight itself, or even result in burning to other materials.
DO NOT use batteries other than the ones mentioned in the “available batteries”, especially rechargeable lithium batteries, otherwise it could lead to the damage of the flashlight, or unexpected danger.

WARNING

Keep out of reach of children.
If the light is about to be put aside for a long time or be transported, please unscrew the tailcap and remove the battery to cut off the circuit.

NOTICE

Ensure battery is inserted with the positive (+) end pointing to the head of the flashlight (LED side).
When the flashlight is turned on, it will go to low as the default mode. Continue to click on and off within 2 seconds after it was turned off to shift between low and high brightness levels. If it is turned on over 2 seconds after it was switched off, it will go directly to low mode as default again.
It is normal for the flashlight not being able to reach 180 lumens when the battery voltage is too low (under 1.0V).
It is normal for the flashlight to blink when the battery is running out.

When the light is first turned on, it will go to low as the default mode. Soft press without fully clicking for momentary on. Cycle through momentary low and high mode by quickly soft pressing, letting go, and soft pressing again. Deep press for constant on (you will hear a click). Continue to click on and off within 2 seconds after it was turned off to shift between low and high brightness levels. If it is turned on over 2 seconds after it was switched off, it will go directly to low mode as default again.

WARRANTY

Within 30 days of purchase: Contact the original seller for repair or replacement.

Within 5 year of purchase: Contact Olight for repair or replacement.

This warranty does not cover normal wear and tear, modifications, misuse, disintegrations, negligence, accidents, improper maintenance, or repair by anyone other than an authorized retailer or Olight itself.