muRata LBWA0ZZ2DS WiFi Module User Manual
- June 6, 2024
- muRata
Table of Contents
LBWA0ZZ2DS User Manual for FCC
Model Name: LBWA0ZZ2DS
FCC ID: VPYLBWA0ZZ2DS
Since this module is not sold to general end-users directly, there is no user
manual of the module.
For the details about this module, please refer to the specification sheet of
the module.
This module should be installed in the host device according to the interface
specification (installation procedure)
The OEM integrator has to be aware not to provide information to the end-user
regarding how to install or remove this RF module in the end user’s manual of
the end product which integrates this module.
The end-user manual shall include all required regulatory information/warning
as shown in the User manual.
This modular is a limited single modular is, without its own power supply
regulation, it can only be installed in the host device according to the
interface specification (installation procedure).
● The following information must be indicated on the host device of this
module.
Contains Transmitter Module FCC ID: VPYLBWA0ZZ2DS
Contains FCC ID: VPYLBWA0ZZ2DS
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
*If it is difficult to describe this statement on the host product due to the size, please describe it in the User’s manual. please describe in the user’s manual and also either describe on the device packaging or on a removable label attached to the device.
●The following statements must be described on the user manual of the host device of this module;
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter.
When installing it in mobile equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines. This equipment should be installed and operated keeping the
radiator at least 20cm or more away from the person’s body.
When installing it in portable equipment.
It is necessary to take a SAR test with your set mounting this module.
Class II permissive change application is necessary using the SAR report.
Please contact Murata.
Note)
Portable equipment: Equipment for which the spaces between the human body and
antenna are used within 20cm.
Mobile equipment: Equipment used at the position in which the spaces between
the human body and antenna exceeded 20cm.