CONAIR 134R Wall Mount Dryer Instruction Manual
- June 6, 2024
- ConAir
Table of Contents
CONAIR 134R Wall Mount Dryer
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, especially when children are present, basic safety pre-cautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
KEEP AWAY FROM WATER
DANGER – Any hair dryer is electrically live even when the switch is off. To reduce the risk of death or injury by electric shock:
- Do not install where unit can fall into a tub or sink. Always return dryer into wall unit after use.
- Always unplug dryer immediately after using.
- Do not use while bathing or in a shower.
- Do not place or store appliance where it can fall or be pulled into a tub or sink.
- Do not place in, or drop into, water or other liquid.
- If an appliance falls into water, “unplug it” immediately. Do not reach into the water.
WARNING – To reduce the risk of burns, electrocution, fire, or injury to persons:
- This appliance should never be left unattended when plugged in.
- This appliance should not be used by, on, or near children or individuals with certain disabilities.
- Use this appliance only for its intended use as described in this manual. Do not use attach-ments not recommended by the manufacturer.
- Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped, damaged, or dropped into water. Return the appliance to a Conair service center for examination and repair.
- Keep the cord away from heated surfaces. Do not pull, twist, or wrap line cord around dryer, even during storage.
- Never block the air openings of the appli-ance or place it on a soft surface, such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair, and the like.
- Never use while sleeping.
- Never drop or insert any object into any opening or hose.
- Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
- Do not use an extension cord to operate dryer.
- Do not direct hot air toward eyes or other heat-sensitive areas.
- Attachments may be hot during use. Allow them to cool before handling.
- Do not place appliance on any surface while it is operating.
- While using the appliance, keep your hair out of it. Keep your hair away from the air inlets.
- Do not use with voltage converter.
- Periodically inspect the wall unit for secure mounting.
SAVE THESE INSTRUCTIONS
GETTING TO KNOW YOUR HAIR DRYER
OPERATING INSTRUCTIONS
This appliance is intended for household use only. Use on Alternating Current
(60 hertz) only. Standard Dryers are designed to operate at 110 to 125 volts
A.C.
This appliance has a polarized plug (one blade is wider than the other). As a
safety feature, this plug will fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician. Do not attempt to defeat this safety
feature.
CHECK ALCI SAFETY FEATURE EVERY TIME YOU USE APPLIANCE.
This appliance is equipped with an Appliance Leakage Circuit Interrupter
(ALCI), a safety feature that renders it inoperable under some abnormal
conditions, such as immersion in water. To make sure the ALCI is functioning
properly, perform the following test. The pur-pose of this test is to allow
you to make sure the water sensing system (ALCI) is working.
- Plug in the appliance and press test button on plug (See appropriate diagram below).
- The appliance will stop working. There will be an audible click and reset button will pop out.
- To reset ALCI with a reset button, unit should be unplugged. Then push reset button in, and reinsert plug into outlet.
- If ALCI is not functioning properly, return appliance to nearest service center.
- It is important that if immersion occurs, this unit be brought to a service center. Do not try to reset.
- Be sure to repeat test every time you use the unit to confirm ALCI is operational.
Should the
appliance go off and the reset but-ton pop up during use, this could indicate
a malfunction in the unit. Remove plug from outlet and allow the hair dryer to
cool. Reinsert plug into outlet.
The appliance should function normally. If not, return to an authorized Conair
Service Center for examination and repair.
SUPER STYLING GUIDE
Your best looks begin with a good haircut that’s well maintained. Always treat
hair well with superior quality shampoos, conditioners, and finishing
products.
DRYING BASICS
- Shampoo and condition hair with products of your choice. Rinse thoroughly. Towel blot hair to remove excess moisture. Section hair. Using the dryer along with your styling brush, direct hot air through a section of hair at a time. Move dryer steadily across each section so that the hot air passes through hair. Direct airflow at hair, not scalp.
- Keep dryer’s air intake vents unobstructed and free from hair while drying.
- To avoid overdrying, do not concentrate heat on any one section for any length of time. Keep dryer moving as you style.
- For quick touch-ups between shampoos, dampen hair with a mist of water before styling with the dryer.
BODY & VOLUME
To create extra volume, turn head upside down while drying. Position the
airflow toward the roots for maximum lift. When hair is dry, toss head back
and brush hair into place.
STRAIGHTENING
Work with hair in sections when creating a super straight look. Using a large
round brush (approximately 2” diameter), hold hair taut in each section and
bend ends slightly under as you dry.
MAKING WAVES
Tousled, natural- looking waves are easily created by grasping hair at the
roots and scrunching between fingertips while drying.
Please register this product at: www.conair.com/registration
CONAIR CORPORATION Service Department 7475 N. Glen Harbor Blvd Glendale, AZ
85307
©2010 CONAIR CORPORATION 05PD3066
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>