DOMO DO523S Food Slicer Instructions
- June 6, 2024
- DOMO
Table of Contents
DOMO DO523S Food Slicer
WARRANTY
SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precautions should always be taken, including the following:
- Read all instructions Keep this manual for future reference.
- Make sure all packaging materials and promotional stickers have been removed before using the appliance for the first time. Make sure children cannot play with the packaging materials.
- This appliance is intended to be used in household and similar applications such as:
- staff kitchen areas in shops, offices and other working environments;
- farmhouses;
- by clients in hotels, motels and other residential type environments;
- bed and breakfast type
- Children should be supervised to ensure that they do not play with the
- This appliance can be used by children aged from 16 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children unless they are older than 16 and supervised.
- Keep the appliance and its cord out of reach of children younger than 16
- All repairs should be carried out by the manufacturer or its aftersales
- Any injury or damage caused by failure to comply with these rules are at your own Neither the manufacturer, importer, or the supplier may be held liable.
ELECTRICAL WARNINGS
- In order to avoid a hazard this appliance must not be supplied through an external switching device, such as a timer or a separate remote control, or connected to a circuit that is regularly switched on and off by the utility.
- The appliance must be disconnected from its power source when not in use, during service and when replacing Allow to cool before putting on or taking off parts, and before cleaning the appliance. To disconnect, turn controls to “OFF” or “0” position, then remove the plug from the wall. Never pull the cord or appliance to remove the plug from the socket.
- Check carefully that the voltage and frequency of the power net match the indications on the rating label of the appliance.
- The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local standards and requirements.
- Do not let the power supply cord hang over the edge of a counter, or touch hot
- Keep the power cord away from hot parts and don’t cover the
- Unwrap the cord completely to prevent overheating of the Do not allow the power cord supply to run underneath or around the unit.
- Never move the appliance by pulling the Make sure the cord cannot get caught in any way. Do not wind the cord around the appliance and do not bend it.
- The appliance may not be used with an extension lead or a multiple
- Do not operate this appliance with a damaged cord or plug or in the event the appliance malfunctions or has been damaged in any manner. Return the appliance to the DOMO Service Department or its service agent for examination, repair, or electrical or mechanical adjustment. Do not try to repair the appliance yourself.
INSTALLATION
- Do not place near flammable materials, gases or explosives.
- Do not use or store this appliance outdoors.
- Always use the appliance on a steady, dry and level surface.
- Never place this appliance near a gas stove or electrical stove or in a place where it may come into contact with a warm appliance.
USE
- Do not use this appliance for other than intended
- Only use the appliance for domestic The manufacturer cannot be held responsible for accidents that result from improper use of the appliance or not following the instructions described in this manual.
- Never leave the appliance unattended while it is
- Do not operate the appliance with wet
- The use of accessories that are not recommended or sold by the manufacturer can cause fire, electrical shock or injuries. Only use the utensils delivered with the appliance.
CLEANING AND MAINTENANCE
- To protect against electrical shock or burns, do not immerse unit, cord, or plug in water or other
- Failure to maintain this appliance in a clean condition could adversely affect the life of the appliance and possibly result in a hazardous situation.
PRODUCT-SPECIFIC WARNINGS
- Never place the slicer near any source of
- The slicer can be used to slice meat, bread, vegetables or Do not slice frozen food or meat with bones, food with a thick skin (e.g. coconuts) or large seeds, rolled roast without removing the string, wrappers (i.e. aluminium foil) or any hard, inedible food parts.
- Do not use the appliance, unless the blade is well in
- Handle the blade with the greatest possible care when you are removing it, cleaning it, or replacing it in the machine. Do not touch the cutting edge of the blade.
- The blade is extremely Be very careful. Make sure that your hand does not get close to the cutting surface.
- This appliance must be used with the sliding feed table and the piece holder in position unless this is not possible due to the size or shape of the food.
- Keep your fingers well away from the sharp blade when the slicer is being
- This kind of appliance cannot function continuously; it is not a professional type of It is necessary to make temporary stops. The maximum continuous usage time is 5 min.
- Never touch the blade when the appliance is in Furthermore, never try to stop the movement of the blade in any way whatsoever.
- The blade comes into contact with food. We advise you to clean the machine each time you use Make sure that you always remove the plug from the mains socket before starting to clean the machine.
- Never immerse the machine in water or any other Never place the machine in a dishwasher.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
PARTS
- On/off switch
- Housing
- Thickness indicator
- Knob (dial) for adjusting the thickness
- Food pusher with finger protection
- Hand protection
- Food carriage
- Safety switch
- Support platform
- Screw for fastening the blade
- Blade
- Foldable tray
BEFORE THE FIRST USE
- Before use, remove all packaging materials and any promotional
- Check that all accessories for the device are present and that the unit is not
- Clean all parts with a moist
- Put the appliance on a level, stable surface and unfold the foldable tray completely so that the four little feet rest on the surface.
- Place a tray or plate at the side of the appliance to catch the
- To prevent food from sticking to the appliance, you can moisten the blade with a wet towel beforehand (see chapter “Dismantling blade”). This also allows you to slice more easily.
Always remove the plug from the mains socket before adding or removing parts or cleaning.
ASSEMBLY HAND PROTECTION
Place the hand protection (6) straight into the openings in the sliding
carriage (7) and press firmly.
ASSEMBLY FOOD CARRIAGE
Place the hooks at the bottom of the food carriage (7) on the edge in the
foldable carriage (12) and press down the food carriage. Carefully check the
food carriage to make sure it is secured properly.
ASSEMBLY FOOD PUSHER
Place the food pusher (5) on top of the hand protection (6).
CAUTION : it is only safe to remove the food pusher if the food that you wish to slice is longer than 15 cm. If using the appliance without the food pusher, then extra care must be taken. Always keep your fingers/thumb well away from the rotating blade.
ADJUST SLICING THICKNESS
The slicing thickness can be adjusted from 1 to 15 mm. Turn the dial (knob)
for adjusting thickness (4), to the desired gauge. The thickness indicator at
the top of the slicer shows the selected thickness.
DISMANTLING BLADE
Turn the screw for fastening the blade (10) clockwise. Adjust the support
platform to the thickest setting so that it is easier to remove the blade. The
blade and the machine casing can be cleaned with a disposable damp cloth. Take
great care: The blade is razor-sharp! Always hold onto it by the screw used
for fastening it.
USE
- Pull the food carriage (7) that is attached to the foldable tray (12) away from the cutting edge of the blade.
- Place the food on the food carriage (7) and push it against the support platform (9) with the food pusher (5).
- Press the safety button (8) and hold it
- Press the on/off switch (1) to start the machine so that the blade starts rotating.
- Keep the on/off switch (1) pressed in for as long as you wish to continue slicing. You can release the safety button (8) when you press in the on/off switch (1).
- Slide the food carriage (7) backward and forwards along the rotating blade (11) on the foldable tray (12).
- Release the on/off switch (1) when you are finished
CAUTION
You must always use the food pusher when slicing food that is smaller than 15
cm x 15 cm. For larger pieces you can remove the food pusher. If you remove
the protection, take extra care!
Hold your fingers well away from the rotating blade.
Never use the machine for longer than 5 minutes in any one session.
First allow the machine to cool down before you use it again.
The blade is not suitable for cutting frozen products or meat with bones.
PREVENT OVERLOADING
The appliance will vibrate slightly if it is overloaded. The blade will rotate
very slowly or it will stop rotating altogether. In that case, the best thing
to do is switch off the machine for 15 minutes to allow it to cool down before
using it again.
CLEANING AND MAINTENANCE
- Remove the plug from the power
- Never immerse the machine in
- Before cleaning the appliance, set the slice thickness to the
- Remove the blade from the slicer by turning the screw in the middle of the blade clockwise and pulling the blade out. Be careful when removing the blade.
- Always clean the slicer immediately after use in order to prevent drying of food
- In order to remove food residues rich in oil it may be necessary to use a detergent and water to clean the
- Never use a pointed or sharp instrument to remove the remains of food from in between the blade and
- The housing can be cleansed with a damp
- The blade, the food carriage and the food pusher must be cleaned in water with non-abrasive detergent/soap. Clean then rinse and dry the parts thoroughly before reassembly.
- Never use aggressive, abrasive cleansing products or scouring pads to clean the electrical
- Do not put the parts in a
- The appliance must be completely clean, dry and cooled off before storing it.
ENVIRONMENTAL GUIDELINES
This symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it must be brought to the applicable collection point for recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. The packaging is recyclable. Please treat the packaging ecologically.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>