VARYTEC VP-M5 Mobile Video BiLight User Guide
- June 6, 2024
- VARYTEC
Table of Contents
VP-m5 Mobile Video BiLight
Quick start guide
This quick start guide contains important information on the safe operation of the product. Read and follow the safety advice and instructions given. Retain the quick start guide for future reference. If you pass the product on to others please include this quick start guide.
Safety instructions
Intended use
This device is intended to be used as a portable video light. Any other use or use under other operating conditions is considered to be improper and may result in personal injury or property damage. No liability will be assumed for damages resulting from improper use.
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and are not within reach of babies and young children. Choking hazard! Ensure that children do not detach any small parts from the product. They could swallow the pieces and choke!
Incorrect handling of lithium batteries can result in injury
In the event of a short circuit, overheating or mechanical damage, lithium batteries can cause severe injuries. When handled correctly and appropriately lithium batteries pose no risk. Store lithium batteries in a cool, dry place, ideally in the original packaging. Store lithium batteries away from heat sources (e.g. radiators or sunlight). Lithium batteries are hermetically sealed. Never attempt to open a lithium battery. If the battery housing is damaged small amounts of the electrolyte may leak out. If this should happen, seal the lithium battery in airtight packaging and wipe up the traces of electrolyte using absorbent paper towels. You must wear protective rubber gloves when doing so. Clean your hands and the affected surface thoroughly with cold water. Never attempt to recharge non-rechargeable lithium batteries. When charging lithium batteries you must use a suitable charging device intended for the purpose. Only use powder extinguishers or other suitable extinguishing agents to extinguish a burning lithium battery.
Eye damage caused by high light intensity
Never look directly into the light source.
Extend the operating life of the device by regular breaks and by avoiding frequent switching on and off. The device is not suitable for continuous operation.
For technological reasons, the light output of LEDs decreases over their
lifetime.
This effect increases with a higher operating temperature. You can extend the
service life of the illuminants by providing adequate ventilation and
operating the LEDs with the lowest possible brightness.
Where to use the product
Never use the product
- in conditions of extreme temperature or humidity
- in extremely dusty or dirty areas
- at locations where the unit can become wet
General handling
- To prevent damage, never use force when handling the product.
- Never immerse the product in water. Just wipe it with a clean dry cloth. Do not use liquid cleaners such as benzene, thinners, or flammable cleaning agents.
Features
• Mini LED video light with variable color temperature and built-in battery| •
USB-C port for charging
---|---
• Steplessly dimmable| • Battery charge level indicator
• Easy operation via rotary controls| • Colour temperature steplessly
adjustable from 2550 – 6140 K
• With 1/4″ internal thread
Operating elements
- Battery charge level indicator
- Connection for hot shoe
- USB-C port
- Brightness control
- On / off switch
- Colour temperature control
Using the product
1. First the internal battery must be charged. To do this, connect the device
to a
suitable voltage source (not supplied) via its USB-C port e.| 5. Set the
desired colour temperature between 2600 – 5700 K with the colour
temperature control y.
---|---
2. Place the device with its connection w on the hot shoe of the camera to be
used| 6. Observe the battery charge level indicator q to estimate the
remaining operating time. If the video light goes out, the internal battery
must be recharged.
3. Press the switch t to switch on the device.| 7. Press the switch t to
switch off the device.
4. Set the desired lighting intensity with the brightness control r.|
Technical specifications
| Light source | 66 × SMD-LED (33 × warm white, 33 × cold white) | |
|---|---|---|
| Light source properties | Colour temperature | |
| Colour rendering index CRI | 2550 – 6140 K, steplessly adjustable |
95
Optical properties| Beam angle
Light output| 120°
800 lm
Input connections| Charging port| USB-C
Power consumption| LEDs| 5W
Power supply| | USB(5V==)
Battery/rechargeable battery| Battery type
Voltage Capacity
Charging time
Operating time| Lithium-Ion
3.7 V
2000 mAh
3.5 h
2 – 10 h (depending on brightness setting)
Protection class| | IP20
Mounting options| | camera hot shoe
Mounting options (W × H × D)| | 92 mm × 21 mm × 78 mm
Weight| | 110 g
Ambient conditions| Temperature range| 0 °C – 40 °C
| | 20 – 80 % (non-condensing)
For
the transport and protective packaging, environmentally friendly materials
have been chosen that can be supplied to normal recycling. Ensure that plastic
bags, packaging, etc. are properly disposed of. Do not just dispose of these
materials with your normal household waste, but make sure that they are
collected for recycling. Please follow the notes and markings on the
packaging.
This product is subject to the European Waste Electrical and Electronic Equipment Directive (WEEE) in its currently valid version. Do not dispose of your old device with your normal household waste. Dispose of this product through an approved waste disposal firm or through your local waste facility. Comply with the rules and regulations that apply in your country. If in doubt, consult your local waste disposal facility.
Batteries must not be disposed of as domestic waste or thrown into the fire. Dispose of batteries according to national or local regulations regarding hazardous waste. Dispose of empty batteries at appropriate collection sites. Dispose of lithium batteries only in discharged condition. Remove replaceable lithium batteries from the device before disposal. Protect used lithium batteries from short circuits, for example by covering the poles with adhesive tape. Permanently installed lithium batteries must be disposed of together with the device. Please inquire about a suitable acceptance point.
Thomann GmbH
• Hans-Thomann-Straße 1
• 96138 Burgebrach
•www.thomann.de
•info@thomann.de.
DocID: 522506_25.02.2022
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>