beko DFS05024W Non-Mountable Dishwasher User Guide
- June 6, 2024
- Beko
Table of Contents
DFS05024W Non-Mountable Dishwasher
User Guide
Operating the product
Read “Safety Instructions” section first!
- On/Off/Programme Selection key
- Rinse Aid indicator
- Salt indicator
- On/Off Control light
- Time Delay indicator (Depends on model)
- Time Delay key (Depends on model)
- Handle
- Programme Follow-up lights
- Start/Pause/Cancel key
- Half Load function/
Auxiliary functions
Washing programmers of your dishwasher are designed to obtain the best cleaning effect, considering the type of the soiling, soiling degree and properties of the dishes to be washed.
Auxiliary functions are provided in order to enable you to save time, water and energy and to perform a more comfortable washing with conditions specific to you.
NOTE: Auxiliary functions may cause changes in the program duration.
The consumption values shown in the table were determined under standard conditions. Differences may therefore occur under practical conditions.
- Reference programme for testing institutes. The tests in accordance with EN 50242/60436 must be carried out with a full water softener salt dispenser and a full rinse aid reservoir, and using the test programme. The values given for programmes other than Eco 50°C programme are indicative only. (#) Additional functions might cause changes in programme durations.
Loading Capacity: 10
Adjusting the water softening system
Washing, rinsing and drying performance of your dishwasher will improve when the water softening system is adjusted correctly.
To adjust the system, first learn the water hardness in your region and adjust as indicated below.
- Unpack the test strip.
- Open the tap and let the water flow for approx. 1 minute.
- Dip in the test strip into the water for 1 second.
- Take out the strip from the water and shake it.
- Wait for 1 minute.
- Make the necessary adjustment according to the test strip.
After detecting the water hardness:
-
When the Programme Selection knob is in Off position, press and hold the Start/Pause/Cancel key and turn the Programme Selection knob clockwise by one level within 5 seconds. Once this time has elapsed, the product will enter the regeneration setting mode.
-
Regeneration level in the memory will be illuminated for 5 seconds when the regenerator adjustment mode is activated.
-
To adjust the new Water Hardness Level, move the Programme Selection knob to the position that is suitable for your supply water. (see, Water Hardness Level Adjustment Table)
**Programme Selection knob rotates in 5 steps regardless of the number of the programmes contained on the machine. -
Press “Start/Pause/Cancel” key for once to store the level you have selected.
-
Bring the Program Selection knob to “OFF” position.
Water hardness level adjustment table
- If the hardness level of the water that you use is above 50°dH or if you are using well water, than it is recommended to use filter and water purification devices.
- If the hardness level of the water that you use is below 7°dH, there is no need to use salt in your dishwasher. In this case, the Salt Indicator light on the control panel of your dishwasher will light continuously.
- If the water hardness is set to level 1, the Salt Indicator will light continuously although it is not necessary to use salt. If you use salt under this condition, salt will not be consumed and the lamp will not illuminate.
Note: When moving, you will need to set the water hardness level of your dishwasher again according to the information above, depending on the water hardness of the place you have moved to. If the water hardness level of your machine is adjusted previously, your machine will display the most recent hardness level adjustment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>