eta 4615455 High-Speed vacuum Blender Instruction Manual

: June 6, 2024
: ETA

Table of Contents

eta 4615455 High-Speed vacuum Blender
SAFETY WARNINGS
FEATURES OF THE DEVICE
PREPARATION FOR USE
USING THE BLENDER
RECIPES
MAINTENANCE
ENVIRONMENTAL PROTECTION
TECHNICAL DATA
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

eta 4615455 High-Speed vacuum Blender

eta 4615455 High-Speed vacuum Blender PRO

SAFETY WARNINGS

Consider the instructions for use as a part of the appliance and pass them on to any other user of the appliance.
Check whether the data on the type label correspond with the voltage in your socket. The power supply plug has to be connected to a socket of electrical installation that conforms to respective standards.
Never use the appliance if the power cord or power plug are damaged, if it is not functioning correctly or if it has fallen on the fl oor and been damaged or if it has fallen into water. In such cases take the appliance to a professional service centre to verify its safety and correct function.
This appliance must not be used by children. Keep the device and its supply cord out of reach of children. The device may be used by persons with reduced physical or mental abilities or lack of experience and knowledge only if they are under supervision or they have been instructed about using the appliance safely and understand the potential dangers. Children must not play with the appliance.
Be careful when pouring hot liquid into the food processing device or the mixer because it may spurt out of the appliance because of the sudden boil.
If the power cord of this appliance is damaged, the cord must be replaced by the manufacturer, their service technician or by a similarly qualified person, this will prevent the creation of a dangerous situation.
Always unplug the appliance from power supply if you leave it unattended.
Before replacing accessories or accessible parts, which move during operation, before assembly and disassembly, before cleaning or maintenance, turn off the appliance and disconnect it from the mains by pulling the power cord from the power socket!
Be careful when handling the blender, the knife is very sharp!
CAUTION : Do not use the appliance with a program, time switch or any other part that turns the appliance on automatically as there is a risk of fire if the appliance is not covered or placed properly.
When the appliance is in operation, prevent pets, plants or insects to get in contact with it.
Every time before the propulsion unit is switched on, the container needs to be attached properly and the lid needs to be placed appropriately so as to close the container.
After finishing work and before cleaning, always switch off the appliance and disconnect it from power supply by taking the power cord connector out of the electric socket.
The product is intended for home use and similar (in shops, offices and similar workplaces, in hotels, motels and other residential environments, in facilities providing accommodation with breakfast). It is not intended for commercial use!
The appliance must not be used in damp or wet environments and in any environment with the danger of fire or explosion (spaces where chemicals, fuels, oils, gases, paints and other flammable or volatile materials are stored).
Maximum time of processing is 3 min. After that, keep the break for approx. 10 min necessary for the motor unit to cool off.
When the jar is fitted to the appliance properly and the protective cover is closed, the safeguards are released and it is possible to switch on the appliance.
The jar is not intended for storage of food. Once mixed, transfer the food into the bottle with lid which is included in the box.
When mixing or stirring liquids, never add more than 1300 ml of liquid, and always use the lid. The maximum hot food volume is limited to 750 ml.
The appliance is equipped with thermal safety fuse which disconnects current supply in case of engine overloading. If it occurs, unplug the appliance and let the appliance get cooled at least 10 minutes.
Never immerse the drive unit into water and do not wash it in running water!
Do not switch on the appliance without ingredients put in!
Do not put more liquid than marked on the dish and always use the lid when mixing or blending liquids.
Do not process ingredients of higher temperature than approx. 80 °C.
Use the mixer only in its working position and at places where there is no risk of tipping and in sufficient distance from heat sources (e.g. heater, stove, cooker, grill etc.) and wet surfaces (sinks, basins etc.)
Use the appliance only with accessory intended for this type of device. Using other accessory may pose danger for the user.
Prevent the supply cord to hang loosely over the edge of the working desk where children could reach it.
The power cord must not be damaged with sharp or hot objects, open fire, it must not be sunk into water or bent over sharp edges. Never put it on hot surfaces or do not let it hang over the edge of a table or work tables. Hitting, stumbling or pulling the power cord e.g. by children can result in tilting over or drawing the appliance down and serious injury!
Use the appliance only with original accessories from the manufacturer.
Use the appliance only for the purpose it is intended for as specified in this manual. Never use the appliance for any other purpose.
The manufacturer is not responsible for damage and injuries caused by improper use of the appliance and the accessories (e.g. food deterioration, injury, cutting) and its guarantee for the appliance does not apply in situations when the safety warnings above are not complied with.

Warning
If the blender runs idle (e.g. the blade cannot touch the ingredients), disconnect it from the mains and release the ingredients. The blender cannot run idle for more than 10 seconds!

FEATURES OF THE DEVICE

eta 4615455 High-Speed vacuum Blender 1

A1 – main switch
A2 – „SMOOTHIE“ programme button
A3 – „SILENT“ programme button
A4 – „VACUUM“ programme button
A5 – stand-by and operation signal lights
A6 – STOP/PAUSE button
A7 – stand-by and operation signal lights
A8 – speed knob
A9 – propulsion shaft
B1 – vacuum signal lights
A10 – supply cord
C1 – handle
C2 – knife
C3 – lid
C4 – lid seal (A)
C5 – lid seal (B)
C6 – valve
C7 – valve seal
D1 – lid with valve
D2 – lid cover

PREPARATION FOR USE

Remove all packaging material, and remove the accessory. Remove all adhesive foils, stickers or paper from the appliance. Before the first use, wash the parts that will be in contact with food in hot water with a detergent, rinse them thoroughly with clean water and wipe till dry, or let them dry. Possible short-time mild smoke when the appliance is operated for the first time is not a defect and the appliance is not subject to a complaint for this reason.

Appliance assembling
Please assemble the appliance according to Fig. 1. When the jar C or bottle D is properly fitted to the actuator and the protective cover B is closed, the safeguards are released and it is possible to use the appliance. Apply the reverse procedure to dismantle.

Control:
Switching to standby mode

Connect driver unit A to the mains.
Place the jar C or bottle D to the actuator and close the protective cover B.
Position the main switch to “I“. You will hear a sound signal and the signal lights A5/A7 will come on.
You can now use the appliance

Caution

Unless you press a button within approx. 180 seconds, the appliance will switch to the energy-saving mode (signal lights A5/A7 will go out). By pressing the A6 button or lifting and closing the protective cover B, the appliance will go back to standby mode.
The bottle D is only used for the vacuum mode. When the bottle is used, only the „VACUUM“ programme is possible (A4 button).
Before you place bottle D onto the actuator, remove the cover D2 from it.

Manual speed setting
(you will hear a signal sound). The appliance will start at the required speed. You can adjust the speed at any time as required. To stop the appliance, turn the knob A8 to position „ “ (you will hear a signal sound).

Note
You can stop the operation by pressing the A6 button (you will hear a signal sound). When you press the A6 button again (you will hear a signal sound), the operation will re-start with the speed set.

Using the maximum speed feature
To use the maximum speed feature, turn the knob A8 to position „ “ (you will hear a signal sound) and keep it there. By releasing the knob A8, the appliance will stop (you will hear a signal sound).

Use of pre-set programmes
Select the programme with the A2, A3 or A4 button. By pressing the relevant button, the selected programme will be started. When the selected programme is finished, the appliance will stop (you will hear a signal sound).

Button| Programme name| Total time (sec.)| Features used| Use
---|---|---|---|---
A2| | SMOOTHIE| 95| vacuum mode

+ mixing

| Preparing fruit and vegetable beverages (smoothies)

A3

| |

SILENT

|

85

| vacuum mode

+ mixing

USING THE BLENDER

Notes

The vacuum process eliminates undesired froth, reduces and slows down oxidation. This keeps the ingredients fresh and lush for a longer time.
When mixing with the air removed, the pulp and liquid are not separated – this delivers exquisite taste and drink consistency.

Put the closed container with the ingredients on the driver unit. After that, either adjust the speed manually or use one of the pre-set programmes (see Control). The blender is intended for preparation of juices, milk cocktails, smoothies, sauces, soups, baby food, diet food, purées, etc.

Recommendation

You can also process hot liquids up to a temperature of 80 °C, e.g. sauces, soups.
Never fill the container with liquids that make foam (e.g. milk) up to 1300 so that they do not overflow. In this case we recommend amounts approx. 750 ml.

RECOMMENDED SPEEDS FOR PROCESSING INGREDIENTS
This is a high-speed blender. The revolutions are within the range of 15000 – 32000 RPM. Always set the speed with regard to the kind and amount of ingredients being processed, and particularly with regard to ripeness of fruit and vegetables.

RECIPES

Consider these following tips for processing examples and inspiration whose purpose is not to provide a manual but to show ways of different food processing.

Raspberry smoothie

Ingredients Amount (1 serving) Amount (2 servings)

raspberries| 100 g| 200 g
bananas| 1 pcs| 2 pcs
cocoa milk| 150 ml| 300 ml

Procedure:
Clean and wash the raspberries. Remove the banana peel and break the bananas into smaller pieces. Then place all the ingredients in the blender and mix them till smooth.

Watermelon smoothie

Ingredients Amount (1 serving) Amount (2 servings)

watermelon| 200 g| 400 g
strawberries| 50 g| 100 g
water| 100 ml| 200 ml

Procedure:
Wash and dry the strawberries as required. We recommend that you rid the watermelon flesh of the seeds before mixing. In case that you leave seeds in the flesh, you can strain the smoothie through a strainer in the end. Mix all the ingredients thoroughly.

Mango smoothie

Ingredients Amount (1 serving) Amount (2 servings)

mango| 1 pcs| 2 pcs
peaches| 1 pcs| 2 pcs
lemon| 1/2 pcs| 1 pcs
water| 100 ml| 200 ml

Procedure:
Wash the peaches, remove the seeds. Wash the mango, remove the seed and peel it. Then put everything in the blender. Flavour with squeezed lemon juice, if required. Finally, mix everything thoroughly.

Carrot and apple smoothie

Ingredients Amount (1 serving) Amount (2 servings)

carrot| 1 pcs| 2 pcs
apples| 1 pcs| 2 pcs
lemon| 1/2 pcs| 1 pcs
water| 100 ml| 200 ml

Procedure:
Wash the carrot and apples, peel and cut them into smaller pieces. Then put everything in the blender. Flavour with squeezed lemon juice, if required. Finally, mix everything thoroughly.

Strawberry cocktail

Ingredients Amount (1 serving) Amount (2 servings)

Procedure:
Clean and wash the strawberries as required. Then put everything in the blender and mix it thoroughly. We recommend using cane sugar for additional sweetening.

MAINTENANCE

Do not use coarse and aggressive cleaning agents (e.g. sharp objects, scrapers, diluting agents or other solvents). Clean drive unit with a soft and wet cloth with a little detergent. Clean all accessories in hot water with a detergent right after use (do not use a dishwasher). To clean the knife, pour about 0.5 litre of clear water in the container and turn on the appliance. In case of larger contamination of the knife, repeat the procedure several times, or pour 1 l of water, add a small amount of detergent and switch the blender on for 1 minute. Some ingredients can colour the accessories in some way. But the change does not affect the function of the appliance and it is not a reason for a claim. This colouring usually disappears after some time. Never dry plastic moldings overa heat source (e. g. heater, electric/gas stove). Store the appliance after cleaning at a dry, dustfree and safe place, out of reach of children and incapacitated people.Contact your manufacturer for spare parts and components.
More extensive maintenance or maintenance requiring intervention in the inner parts of the appliance must be carried out by professional service! Failure to comply with the instructions of the manufacturer will lead to expiration of the right to warranty repair!

ENVIRONMENTAL PROTECTION

If the dimensions allow, there are labels of materials used for production of packing, components and accessories as well as their recycling on all parts. The symbols specified on the product or in the accompanying documentation mean that the used electric or electronic products must not be disposed of together with municipal waste. For proper disposal of the product, hand it over at special collection places where it will be taken over free of charge. Suitable disposal of the product can help to maintain valuable natural resources and to prevent possible negative impacts on the environment and human health, which could be the possible consequences of improper waste disposal. Ask for more details at the local authorities or in the nearest collection site. Fines can be imposed for improper disposal of this type of waste in agreement with the national regulations.If the appliance is to be put out of operation for good, after disconnecting it from power supply we recommend cutting off the power cord and thus it will not be possible to use the appliance again.

TECHNICAL DATA

Voltage (V) shown on the type label of the appliance
Input (W) shown on the type label of the appliance
Container volume (mI) about Weight (kg) about 1300
- Protection class of the appliance Size of the product (mm) 7.0
Input in standby mode is < 0.50 W. Input in off mode is 0.00 W.

Noise level:
Acoustic noise level of 85 dB (A) re 1pW The manufacturer reserves the right to change the technical specifications and accessories for the respective models. WARNINGS AND SYMBOLS USED ON THE APPLIANCE, PACKAGING OR IN THE INSTRUCTIONS MANUAL: HOUSEHOLD USE ONLY. DO NOT IMMERSE IN WATER OR OTHER LIQUIDS. TO AVOID DANGER OF SUFFOCATION, KEEP THIS PLASTIC BAG AWAY FROM BABIES AND CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS, CARRIAGES OR PLAYPENS. THIS BAG IS NOT A TOY.