SHARP PN-65HC1 LCD Monitor Big Pad Instructions

  PN-65HC1 Dismantle Instruction

LCD MONITOR

MODEL PN-65HC1

Dismantle Instruction

1. Scope

This document describes dismantling instruction according to Annex VII of Directive 2012/19/EU.

2. Tools for dismantling

Below tools are required to dismantle this product.
– Screw Driver
– Nipper

3. Dismantle Procedure

This product can be dismantled by below steps.

1. Remove Back covers (section 4)
2. Remove the shielding
3. Remove Printed circuit boards (section 5)
4. Remove battery (section 6)
5. Dismantle LCD (section 7)
6. Remove Electrolyte Capacitors (section 8)

4. Back cover

Back cover can be removed by screw driver.

5. Printed circuit boards

All PWBs can be removed by screw driver.

Main PWB (1pcs)                                      T-con PWB (1pcs)

Power PWB (1pcs)                                     OPS PWB(1pcs)

6. Batteries

This model uses CR2032 Lithium Coin battery on MAIN PWB.
Battery CR2032 can easily be removed from the battery holder.

This model uses AAA battery for remote control.
Battery can easily be removed.

7. LCD Module bezels/bracket
LCD Dismantle procedure

1. Remove screws
2. Remove Cover glass and Bezels
3. Remove screws
4. Remove Middle Frame
5. After you have removed the PWB´s, the cover glass and bezels please take out the cables from the LCD module.

8. Capacitors

Electrolyte Capacitors which diameter/height is larger than 25mm is installed on the Power PWB. These capacitors can be removed by using nipper to cut the leads.

9. Parts List

Parts described in Annex VII of directive 2012/19/EU are as below.

– CEE 7 (for EU)
– Type-BF (for UK)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>