EMOS ZC0108 LED Orientation Luminaire Installation Guide
- June 6, 2024
- EMOS
Table of Contents
EMOS ZC0108 LED Orientation Luminaire
OVERVIEW
INSTALLATION
GB | LED Orientation Luminaire – Built-in
The LED Luminaire is designed to be installed onto a solid base in indoor or
outdoor areas. Enclosure: IP65 ‒ for outdoor environments.
Inspect the Luminaire before use. If any part is damaged, do not use the
product. Before assembly, make sure power supply is disconnected. In case of
malfunction, do not try to repair or dismantle the Luminaire. The LEDs are not
replaceable. Failure to observe any instructions provided in the manual may
result in personal injury or property damage.
Installation
The installation box must be firmly fixed in the wall/base to prevent its
damaging. Attach the Lumi-naire securely to a fixed base in the wall. Connect
the power cable for connecting to a 230 V~ power network. The conductor must
not be connected to power supply at the time of Luminaire installation. The
power cable must be connected to the Luminaire only by a professional with
qualification in accordance with Decree No. 50/1978 Coll., as amended, at the
least a professional knowledgeable in line with section 5 of Decree No.
50/1978 Coll., as amended.
WARNING
- The Luminaire is only suited for fixed installation.
- The Luminaire can only be connected to an electrical network with installation and protection in line with valid regulations and standards.
- Before interfering with the Luminaire or performing maintenance and repair, the Luminaire must be disconnected from the power network. This must only be performed by a person knowledgeable in valid regulations on qualification for such activities.
- Protection against dangerous contact voltage is ensured through earthing.
- Immediately take the Luminaire out of operation if any portion of the Luminaire becomes damaged.
- LEDs inside the Luminaire are not replaceable.
- Do not interfere with the internal wiring of the Luminaire.
- Never cover the Luminaire with materials for thermal insulation.
- If the Luminaire cover becomes damaged, do not use the Luminaire and immediately replace the cover with a new one.
Type| Power supply| Input power| Luminous flux| Chromatic temperature| Product
size| Installation opening
---|---|---|---|---|---|---
ZC0108| 220–240 V~,
50/60 Hz
| 1.5 W| 60 lm| 3 000 K| 123 × 53 mm| 113 × 43 × 65 mm
ZC0109| 220–240 V~,
50/60 Hz
| 2 W| 65 lm| 3 000 K| 80 × 80 mm| 70 × 70 × 65 mm
Do not cover the lamp with material for thermal insulation
EMOS spol. s r.o. declares that the ZC0108, ZC0109 is in compliance with the
essential requirements and other relevant provisions of Directive. The device
can be freely operated in the EU. The Declaration of Conformity can be found
at http://www.emos.eu/download.
Do not dispose with domestic waste. Use special collection points for sorted waste. Contact local authorities for information about collection points. If the electronic devices would be disposed on landfi ll, dangerous substanoes may reach groundwater and subsequently food chain, where it could affect human health.
References
- Ke stažení - EMOS | Elektro eshop a velkoobchodEMOS | Elektro eshop a velkoobchod
- ist.Im
- EMOS | Elektro eshop a velkoobchodEMOS | Elektro eshop a velkoobchod
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>