Conductix Wampfler CXWA Wireless Controller User Manual
- June 6, 2024
- Conductix Wampfler
Table of Contents
Supplemental User’s Manual
INTEGRATION INSTRUCTIONS per FCC KDB 996369 D03, Section 2.0
2.2 List of applicable FCC rules
The module has been certified for use under FCC Part 15.249 only
2.3 Summarize the specific operational use conditions
The host device must be tested for spurious emissions due to the module’s lack
of its own shielding.
2.4 Limited module procedures
The host device must be tested for spurious emissions due to the module’s lack
of its own shielding.
2.5 Trace antenna designs
Antenna is integrated into module and the module should be used with no other
antennas
2.6 RF exposure considerations
Device is inherently compliant with RF exposure requirements since it meets
15.249 requirements
2.7 Antennas
Antenna is integrated into module and the module should be used with no other
antennas
2.8 Label and compliance information
Module contains its own label
2.9 Information on test modes and additional testing requirements
None required.
2.10 Additional testing, Part 15 Subpart B disclaimer
This module has been tested and certified to comply with FCC Part 15C
requirements. The host device to which it is installed may require additional
testing to show compliance with FCC Part 15B requirements.
Notice:
OEM should include the following warnings on the label:
“Contains FCC ID: 2ASM6-CXWA, IC:11769A-CXWA” As well as the model name:
“VersaReel Blue” Installer should include the following in the user’s manual:
“This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.”
“Changes of modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.”
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>