LOPOLIGHT 201-011 Series Masthead Light with Deck Light Installation Guide

October 27, 2023
LOPOLIGHT

LOPOLIGHT 201-011 Series Masthead Light with Deck Light

LOPOLIGHT-201-011-Series-Masthead-Light-with-Deck-Light-
PRO

Mounting

  • Go to www.lopolight.com or use the QR code to get to the ‘products’ section where the datasheet that includes the dimensional drawing is found.
  • For directional lights the alignment to the vessel centerline is very important.
  • Horizontally mounted lights are opened/closed as illustrated, please ensure lock screw engages correctly.

Connecting power

  • Supply Voltage: Any DC voltage between 10 and 32 volts. (12 and 24 Volt systems)

  • Cabled lights: Red wire: Positive (+) Black wire: Negative ( – ). (Double light: 2 cables, same colour coding)

  • **Light with green connector:

**

  *  **Single light:** Pin 1: Positive (+) Pin 2: Negative ( – ) (pin 3-5: not used) Double light:
  *  **Primary light:** Pin 1: Positive (+) Pin 2: Negative ( – )
  *  **Secondary light:** Pin 4: Positive (+) Pin 5: Negative ( – ) (pin 3 not used)
  • Recommended fuse or circuit breaker: Less than 2A (slow).
  • Grounding: The navigation light housing should not be connected to ground (Earth). (We recommend that you connect the cable screen to ground (Earth)).
  • Cabling: Avoid chafe and route it away from sources of heat and large inductive fields such as electric motors.

Cleaning your product:

  • Wipe off your product with a normal detergent, on a damp cloth DO NOT use alcohol or thinner for cleaning your light – this could damage the lens.

Troubleshooting

If the light does not function:

  • Check that you have a supply Voltage between 10 and 32 Volt DC.
  • Check that the polarity is right (you will not damage the Lopolight by accidentally wiring the polarity wrong).

End of life signaling:
Your Lopolight product has a microprocessor inside that ensures that thee light has required intensity over a 50.000-hour projected lifetime. The light will signal to you when it is getting to the end of its useful life. The following signals can be observed:

  • All OK: 5 seconds after turning on the light it will go dark for 0,1 second and turn on again. This is just a check for you to assure that the microprocessor is working.
  • Less than 2000 working hours left: The dark period is extended to 2 seconds: you should change the light at your next service within the next 12 months.
  • Light Expired: The dark period is extended to 5 seconds: You should change the light immediately. (The light will still be working, even in the expired state)

Warranty

  • This product is covered by our 5-year limited warranty.
  • If you want to claim a warranty for your product, please fill in the form at www.lopolight.com/service

Approvals:
The light in this package is type approved to the following standards:

  • EN-14744, UL-1104, COLREG72, IEC 60945 Recognized by the following authorities:
  • IMO, MED (EU-wheelmark), USCG

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals