Silex technology SXNEWAH Embedded Wireless Module User Manual

June 6, 2024
silex technology

User Manual

Since this module is not sold to general end-users directly, there is no user manual for the module.
For the details about this module, please refer to the specification sheet for the module.
This module should be installed in the host device according to the interface specification (installation procedure).

FCC Notice

This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

List of applicable FCC rules

This device complies with part 15 of the FCC Rules.
Part 15 Subpart C

Additional testing, Part 15 Subpart B disclaimer

The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the grant, and the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification.
The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed.
Summarize the specific operational use conditions
This module is designed for mounting inside of the end product by the end- product manufacturer professionally.
Therefore, it complies with the antenna and transmission system requirements of §15.203.
RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed and operated keeping the radiator at least 20cm or more away from the personʼs body.
Co-Location Rule
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. Label and compliance information
The following information must be indicated on the host device of this module.
Contains Transmitter Module FCC ID: N6C-SXNEWAH
Or
Contains FCC ID: N6C-SXNEWAH

**FCC CAUTION

**

The following statements must be described on the user manual of the host device of this module;
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could
void the userʼs authority to operate the equipment.

Antenna List

Vender Model No. Antenna Type Antenna Gain [dBi]
STAF T16-062-1022 PCB 3.0
ethertronics 9000984-XLPDNB ROD 3.
PSA (Walsin) RFDPA131000SMRB801 ROD 3.
Index AN0915-13D01BSM ROD 2.00
Simon Technology SME—G0900DEN ROD 1.
Taoglas IS.05.B.3010021 thread-mount 2.40

Limited module procedures
This module needs to supply a regulated voltage to VDDFEM from host device.

ISED Notice

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadaʼs licence-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

Label and compliance information
The following information must be indicated on the host device of this module.
Contains Transmitter Module IC: 4908A-SXNEWAH
Or
Contains IC: 4908A-SXNEWAH
RF exposure considerations
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment and meets RSS-102 of the ISED radio frequency (RF) Exposure rules. This equipment should be installed and operated keeping the radiator at least 20cm or more away from the personʼs body.

Antenna Type

This radio transmitter (4908A-SXNEWAH) has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.

Antenna Type Gain Impedance
Rod Antenna 3.4dBi 50ohms
PCB Antenna 3.0dBi 50ohms
thread-mount Antenna 2.40dBi 50ohms

Limited module procedures
This module needs to supply a regulated voltage to VDDFEM from host device.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

silex technology User Manuals

Related Manuals