silex technology 23BT BLE Module User Manual
- June 5, 2024
- silex technology
Table of Contents
silex
technology 23BT BLE Module
User Manual
23BT BLE Module
Since this module is not sold to general end-users directly, there is no user
manual for the module.
For the details about this module, please refer to the specification sheet for
the module.
This module should be installed in the host device according to the interface
specification (installation procedure).
FCC Notice
This device complies with Part 15 of FCC Rules. Operation is subject to the
following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
List of applicable FCC rules
This device complies with part 15 of the FCC Rules.
Part 15 Subpart C
Test Modes
silex technology, Inc. uses various test mode programs for test set up which
operate separately from production firmware. Host integrators should contact
silex technology, Inc. for assistance with test modes needed for module/host
compliance test requirements.
Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts
(i.e., FCC transmitter rules) listed on the grant, and the host product
manufacturer is responsible for compliance with any other FCC rules that apply
to the host not covered by the modular transmitter grant of certification.
The final host product still requires Part 15 Subpart B compliance testing
with the modular transmitter installed.
RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines as this equipment has very low levels of RF energy.
Co-Location Rule
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter.
Label and compliance information
The following information must be indicated on the host device of this module.
Contains Transmitter Module FCC ID: N6C-23BT
Or
Contains FCC ID:N6C-23BT
FCC CAUTION
The following statements must be described on the user manual of the host
device of this module;
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Antenna List
Vender | Model No. | Antenna Type | Antenna Gain [dBi] |
---|---|---|---|
Unictron | CW324S | CHIP (On board) | 1.6 |
Unictron | H2B1PC1A1C (AA258) | PCB | 2.9 |
ISED Notice
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Label and compliance information
The following information must be indicated on the host device of this module.
Les informations suivantes doivent être indiquées sur le périphérique hôte de
ce module.
Contains Transmitter Module IC: 4908A-23BT
Or
Contains IC: 4908A-23BT
RF exposure considerations
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment and meets RSS-102 of the ISED radio frequency (RF)
Exposure rules as this equipment has very low levels of RF energy.
Antenna Type
This radio transmitter (4908A-23BT) has been approved by Innovation, Science, and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited from use with this device.
Antenna Type | Gain | Impedance |
---|---|---|
CHIP Antenna (On Board) | 1.6dBi | 50ohms |
PCB Antenna | 2.9dBi | 50ohms |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>