COMPASS 09263 Wall Mounted Tyre Holder User Manual
- October 30, 2023
- COMPASS
Table of Contents
… a little bit different company
Wall mounted tyre holder
User Manual
Read this manual carefully before first use.
Set of 4x Tyre holders for wall mounting. Tyre storage with the ese holders
saves space.
The holders are made of a steel and are use full for hanging tyres with a disc
behind the center hole. Self adhesive foam protectors are included to prevent
scratching the discs.
Each holder is designed for one tyre with or without a disc, up to a weight of
30 kg and a maximum width of 29 cm.
Caution
- WARNING: Do not allow persons to operate or install this tyre holder until they have read this manual and thoroughly understood how the product works.
- The warnings, cautions and instructions in these operating instructions cannot cover all possible conditions or situations that may arise. All general safety rules must be observed when using this product.
- Never overload each holder with a load greater than 30 kg.
- Never move under a suspended tyre.
- You must ensure that people (including children) with reduced physical, sensory or mental capabilities, including pets, cannot move under the suspended tyre.
- Never place other objects under the suspended tyres
- The holder can only be used as described in this manual, it is not intended for hanging of people, animals or objects other than tyres.
- Never use the holder if it is damaged or corroded.
- Never adjust the holder, the disc must be secured with arm ending that prevents the disc from slipping.
- The holder is designed for indoor installation.
Instructions for installation and use:
Attach the holders to a solid wall using dowels and screws so that they are secured through all available holes. Glue the protectors to the top part of the holder arms. Place the tyres on the holder arm so that the center hole of the disc rests on the bracket.
Installation instructions
- The holders must be fixed to a solid wall capable of withstanding the specified load.
- The enclosed dowels with screws are intended for a solid brick wall, they cannot be used for other wall constructions.
- List of unsuitable wall constructions for fixing the holders in which it is not possible to make a firm anchorage:
- Plasterboard
- Gas silicate blocks (Hebel, Ytong, etc.)
- Thin wooden walls
- Particles made of chipboard or OSB
- Other less solid constructions
Maintenance
Keep the brackets in good condition, check regularly for corrosion or other material degradation and / or visible mechanical damage.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>