martec TLRD3459WD 9W Tricolour LED Downlight Matt Installation Guide
- June 6, 2024
- martec
Table of Contents
REX Installation Guide
We strongly recommend that you read this manual carefully before installation.
Models
TLRD3459WD
TLRD3459MD| Parameters
9W Tricolour LED Downlight Matt White
9W Tricolour LED Downlight Matt Black| Application
• Residential
• Apartment
•Retro-fit| Dimensions
---|---|---|---
Installation Instructions
Fg.1| Fg.2| Fg.3| Fg.4
| Fg.5
---|---|---|---|---
Disconnect the mains supply before installation or removing the cover. (See
Fg.1)| Cut a Ø90mm hole in the ceiling. (See Fg.2)| Insert the plug into the
socket. (See Fg.3)| Toggle the button to select the colour
temperature required. Push the spring
up and place an LED downlight in the
ceiling. (See Fg.4)| Release the spring and make sure the LED downlight is
firmly in place. (See Fg.5)
Insulation
Thermal insulation clearance class IC-4 covered; meaning that the LED downlight can be covered entirely by insulation abutting or is within 100mm horizontally of the fitting. And must meet the following requirement: i) be a type that can maintain its dimensions and structural integrity when exposed to a maximum surface temperature ii) be of a type that can withstand a 30s needle flame test carried out in accordance with AS/NZS 60598.2.2 with a flame applied to all surfaces of the sample insulation types which should be used with this fitting are glass wool (pink bans) & polyester.
IMPORTANT NOTE
This fitting must not be installed with loose-fill insulation (as defined in
NZS 4246) such as macerated paper and wool. Control gear/driver must be
mounted above any insulation covering the fitting. The minimum side clearance
is 25mm. The minimum height clearance is 20mm.
Aust/NZ Approval No.
xxx xxxx
E: sales@martecltd.com.au | P: 02 8778
7500
www.martecaustralia.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>