CRAFTMADE WPS-100 Smart WiFi Wall Plug Installation Guide
- June 6, 2024
- CRAFTMADE
Table of Contents
CRAFTMADE WPS-100 SmartWiFi Wall Plug
WARNING:
RISK OF ELECTRIC SHOCK
This product installation requires handling 120 volt wiring. Follow each step carefully.= If any concerns handling wiring, hire a qualified electrician. Ensure all work meets local and federal regulations.
Simple DIY Setup
- Download the Craftmade Smart app.
- Add your Craftmade Smart Plug the Craftmade Smart app.
Compatibility Requirements
- Rating 120V AC 60Hz.
- Wi-Fi 802.11 b/g/n @ 2.4 GHZ is required.
- Works with compatible LED bulbs.
- 10A,1200W, General Use;1/3 HP motor
Alternate Connection Procedure
Smart mode networking
Preconditions: Connect to the load, reset state long press plug 10S to reset the load)
-
Click “+” in the upper right corner (or click Add Device)
-
Select the device type as Socket (Wi-Fi)
-
Connect to Wi-Fi, enter the password of Wi-Fi account, and click “Next”.
-
The network is being distributed.
-
Your device should show successfully added.
-
Enter the device control page.
Additional Information and Warnings
FCC Compliance Statement Compliance Notice:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are design-ed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no gua-rantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of FCC rules. Operation is subject to the following two conditions.
- This device may not cause harmful interference.
- This device must accept any interference received, including interferenc e that may cause undesired operation.
Changes or modifications that are not expressly approved by the manufacturer could void the user’s authority to operate the equipment.
CAN ICES-3 (B)/NMB-3(B)
Model: model no WPS-100
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
CAUTION: FOR CONTROL OF INCANDESCENT OR LED LUMINAIRES ONLY.
RF Exposure information:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. In order to avoid the possibility of exceeding the
FCC radio frequency exposure limits, human proximity to the antenna shall not
be less than 8 inches during normal operation.
RF Exposure statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This transmitter must be installed to provide a separation distance of at least 8 inches from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter.
CAUTION – To reduce the risk of overheating and possible damage to other equipment. Do not install to control a receptacle or motor-operated appliance or transformer-suppled appliance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>