Molonlave Group RBW100UVC Disinfectant Charger User Guide

**Molonlave**

User Guide

RBW100UVC
www.rushcharge.com

Getting Started

1. LED Charge Meter
2. UVC display
3. UVC LED
4. On/Off
5. Output 1
6. Type-C USB Input/Output
7. Lighting USB Input
8. Micro USB Input
9. Output 2
10. Wireless charger

USB Cable:

Dual Charging Your Rush Charge

When charging multiple devices with USB: the output will be 1.5A

When charging one single device: the output will be 3.1A.
Red LED: 1-25% Charged
Yellow LED: 25-50% Charged
Blue LED: 50-75% Charged
Green LED: 75-100% Charged

• The LED lights are an approximate representation of the available battery power.
  WARNING : The battery shall not be exposed to excessive heat such as sunshine, fire, or other high temperatures, it contains a polymer battery.

Do not dispose of units with general waste. Contains a lithium polymer battery. Please return it to the battery recycling collection center. For recycling center near you, call +1 352-323-3500

• Charge Power Bank before use.
• Full Power Bank charging time is approximately 4-5 hours.
• Charge Power Bank by using your mobile device’s charging cable or use the 3 in 1 charging cable included.
• DO NOT USE any defective charging cables

Charging Your Smartphone with Power Bank

• When the power bank is fully charged, the LED display will show “Green”

Charging Your Smartphone with Wireless charging

1. Press the ON/OFF button and the RC LED display will turn on to indicate wireless charging is enabled.
2. The display will go into sleep mode after 35s without use.
3. Press ON/OFF to wake from sleep mode. The display will turn on again and wireless charging is enabled.
4. Lay the phone on top of the wireless charger to charge wirelessly, as shown in the photo.

Charging Your UVC LED

• Press the “ON/OFF” button for 3 seconds to turn ON the UVC led.
• keep 1.5–2 cm from any device you want to sanitize (like your phones, wallets, watches, bags, headsets, eating utensils, or clothing. Anything you need to disinfect). It only takes 5-10 mins!
• Kills 99.9% of Germs Viruses fungus, particularly for the Escherichia coli, Pseudomonas aeruginosa, Staphylococcus aureus, Candida albicans.

SAFETY PRECAUTIONS

1. Do not look directly at the UV light when lit to avoid eye damage; Avoid prolonged exposure to humans and animals without protective gear and clothing.
2. Store in a dry protected area to avoid moisture damage. Recommended storage temperature range is 5 ℃ to 30 ℃ and a maximum humidity of RH50%.

Rush Charge can also be used to charge iPods, MP3 players, mobile phones, smart phones, iPods, micro USB compatible tablets, electronic vaporizers, e-readers, portable  aming
devices, headphones, digital cameras, camcorders, video game console controllers, portable speakers, power banks, charging cases, and much more.

Specification

FCC Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. · NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Made in P.R.C.
Designed with • in New York City

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>