Wildix WP480G WorkForce Wi-Fi Dongle User Guide
- June 5, 2024
- Wildix
Table of Contents
WORKFORCE WIFI DONGLE USER GUIDE
PACKING LIST
- 1 x WorkForce WiFi Dongle
- 1 x Type-C adapter
Note: The dongle support starts from WorkForce firmware v. 65.145.4.12.
SAFETY INFORMATION
https://www.wildix.com/safety-information/
WI-FI DONGLE CONNECTION
- Connect WorkForce WiFi Dongle to Type-C adapter
- Plug the Dongle into the WorkForce USB Type-C port
Notes:
- Check that ACL rule “Can use” – “Advanced phone settings menu” is set in WMS -> Users -> Groups for users who need access to the feature
- WorkForce with a connected dongle requires at least a 5V 2A power source
- Wi-Fi Bridge mode is not supported
NETWORK CONNECTION
To connect WorkForce to a Wi-Fi network:
- Press the Menu soft key on WorkForce
- Go to the Network menu and select the WLAN option
- Enable Wi-Fi connection: use Navigation keys or press the Switch soft key to change the Wi-Fi connection status from Disable to Enable; press the Save soft key
- Searching for Wi-Fi Networks is in progress. After it is completed, there is a list of all available networks
- Select a Wi-Fi network from the list and press Connect soft key
- Enter the password and press the Save soft key
- The workForce is now connected to the Wi-Fi network; the LED indicator blinks with fast short blue flashes during data transfer
Full guide online: https://confluence.wildix.com/x/Ygo8AQ
www.wildix.com
Documents / Resources
|
Wildix WP480G WorkForce Wi-Fi
Dongle
[pdf] User Guide
WP480G WorkForce Wi-Fi Dongle, WP480G, WorkForce Wi-Fi Dongle
---|---
References
- Wildix PBX | VoIP Solutions | Unified Communications | WebRTC
- Regulatory Compliance & Safety Information for Wildix Products • Wildix
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>