BOOMPODS ZERO Bluetooth Speaker User Guide
- June 5, 2024
- Boompods
Table of Contents
BOOMPODS ZERO Bluetooth Speaker
IN THE BOX
BLUETOOTH
SETTINGS
BATTERY
Technical Specifications
- Model No ZERO
- Type Bluetooth speaker
- Colors black/black, black/red, grey/ice blue. grey/white
- Compatibility Classic BLUETOOTH devices with Bluetooth 5
- Warranty 12 months
- IPX Rating IPX 6
- Play Time 4H-5 70% volume
- Features play/pause, TWS, Selfie control, wireless charge, type c charge, V+ V-, CALL
- Cables USBA to C type charge cable
- Battery 3.7vdc 250mah
- DRIVER: 4R 3W, 30mm
- Charge time 1.5H
- frequency range 20-20Khz
- Microphone Type ECM microphone
- Sensitivity 42db+/-3db
- Microphone frequency range 20hz-20khz
- Operating temperature -20C- 60C
- Bluetooth Bluetooth 5.0
Function Details
- Press and hold for 2 seconds: Power on
- Press and hold for 4 seconds: Power off
- Click the Selfie function when the Camera is on.
- Double dlicks Play/ Pause
- Triple Click Volume up
- Press and hold for 1.5s: Volume down
- Click Pick up phone/ hung up call
- Double dick Refuse call
- Reset (when the speaker is dead) : Press and hold for 8-10 seconds
- Two dual pairings the other one. : Each one is in pairing mode, it will search for
FCC STATEMENT
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible for compliance
could void your authority to operate the equipment. The device has been
evaluated to meet general RF exposure requirement, the device can be used in
portable exposure conditions without restriction.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.