JLAB Jbuds Air ANC True Wireless Earbuds User Guide
- June 5, 2024
- JLab
Table of Contents
JLAB Jbuds Air ANC True Wireless Earbuds
FIRST TIME SETUP
-
AUTO-CONNECTING EARBUDS
Press and hold both touch Mr’ISOl’S 3+ MCOnds to power ON.
One earbud blinks blue-white indicating ready to pair to your device. -
CONNECTING BLUETOOTH
Select JLab JBuds Air ANC in your device settings. Voice prompt “Bluetooth connected” followed by solid white lights will indicate you are connected.
ADDING NEW/ADDITIONAL BLUETOOTH DEVICES:
Tl.m OFF BIU91Doth from any previously connected device. Tl.m ON Bluetooth
from new device. Earbuds will automatically enter Bluetooth Pairing.
Select” JLab JBuds Air ANC In new device settings to connect.
BUTTON FUNCTIONS
MUSIC / MOVIE MODE: Prass and hold both touch sensors
simuttaneously3+seoonds
POWER OFF WITHOUT CHARGING CASE: Tum off your Bluetooth from your device
settings. The earbuds will then power off after 3 minutes.
EQ SETTINGS: Voice prompts will indicate EQ settings.
CHARGING EARBUDS
Match the corresponding LanclRlettersonthecharglng case for proper charging.
Theearbudswillautopower OFF and start charging.
Blue lights will indicate earbuds are charging and will turn OFF when fully
charged.
Earbuds with auto power ON and reconnect to your device once taken out from the charging case.
CHARGING CASE
VOICE PROMPTS
Ready to Pair: JBuds Air ANC is ready to pair to Bluetooth device Bluetooth Connected”: Earbuds connected to device
FITTING
QUICK TIPS
-
Fully dry off the earbuds before putting ln the charging case to avoid any damage to the case. The earbuds are sweetwater resistant but the case is not.
-
Either earbud can connect to your device and be used independently.
Simply take out the earbud from charging case and it will auto connect. -
Choosing the correct ear tip makes a significant improvement in audio quality due to proper deal for the driver. Try all ear tips for best nuts.
For full User Manual and troubleshooting, please visit JLABAUDIO.COM
TROUBLESHOOTING
No audio in one earbud or earbuds disconnected (Manual Reset)
- Enter your Bluetooth device settings and forget the JBuds Air ANC.
- Open the charging case and keep the earbuds inside.
- On ONE earbud, quickly tap 7x the touch sensor. The light blinks blue 3x then turns off.
- Wait 10 seconds and open the charging case. Weit for one of the earbuds to blink blue-white. You are now ready to pair to your Bluetooth device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>