Pro FPP12216 Wireless Digital Room Thermostat Installation Guide
- June 5, 2024
- Pro
Table of Contents
Pro FPP12216 Wireless Digital Room Thermostat
Installation Notes
- The RF link between the Wireless Digital Room Thermostat and the Relay Box in this pack is pre-configured at the factory and therefore should be installed at the same site.
- If products from individual system packs are separated, or mixed with other pre-configured system packs during installation, or a faulty unit is being replaced, the desired units must be specially configured to allow them to communicate with each other. This process is called Binding. Please refer to section 6) Binding / Rebinding Procedure.
- The Wireless Digital Room Thermostat or Relay box will not communicate with other RF products that use different frequencies or communications protocols.
- The Wireless Digital Room Thermostat requires no power source other than the batteries provided.
- The Relay Box requires a permanent 230V~ supply.
- The Relay Box should be installed before commencing the Wireless Digital Room Thermostat installation.
Installing the Relay Box
For best performance, install in an open space. Leave at least 30cm distance
from any metal objects including wall boxes and boiler housing. Do not mount
on metal wall boxes.
EMC compliance considerations
Keep AC mains supply/load cables separate from signal wiring.
Refer to Code of Practice standards EN61000-5-1 and -2 for guidance.
Installing the Wireless Digital Room Thermostat
Before mounting Wireless Digital Room Thermostat onto the backplate
Power up
RF Communication Test
Locating the Wireless Digital Room Thermostat
For best performance, install in an open space where Wireless Digital Room
Thermostat can sense the room temperature, and where the signal strength is
high.
The Wireless Digital Room Thermostat can be mounted on a wall or on the
optional table stand.
Leave at least 30cm distance from any metal objects and at least 1 metre from
any other electrical equipment.
Select the preferred location and test the Signal Strength before
installation.
Signal Strength Test
Mounting the Wireless Digital Room Thermostat
Test & Binding Flow-chart
Basic System Operation
Automatic Operation
Temporary Manual Override
Press button to temporarily override the current relay position
Loss of RF communications
If RF communication is lost, red LED lights and Relay Box operates in failsafe mode, as set in Installer Mode
Installer Mode
To enter Installer Mode
To select a parameter
Display
To change a parameter
To exit Installer Mode
Parameter flowchart
Parameters
Binding/Rebinding Procedure
The binding operation shown is required if:
- any of the system components (Wireless Digital Room Thermostat or Relay Box) are replaced
- Relay Box has incorrect or no binding data stored (for example, when pre-bound system pack components have been mismatched).
Reset stored data in Relay Box 
Put Relay Box into Binding Mode 
Reset stored data in Wireless Digital Room Thermostat
Put Wireless Digital Room Thermostat into Binding Mode 
Bind Wireless Digital Room Thermostat to Relay Box 
Now go to Section 3.2 RF Communication Test
Primaflow F&P LTD, unit 1A Votec House, Hambridge Lane, Newbury, RG145TN t: 01788 527701 w: primaflowfandp.co.uk
Registered office: Votec House, Hambridge Lane, Newbury RG14 5TN Registered No. 02662075 England VAT No. 340 049 632
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>