SAMSUNG SKK8MC Multi-Control Kit Instruction Manual
- June 5, 2024
- Samsung
Table of Contents
SAMSUNG SKK8MC Multi-Control Kit
Components
CAUTION
Proceed to STEP 4 of the ‘Stacking Kit Installation Instructions’ provided
with the SKK-8K stacking kit. Then, on the back of the washer, assemble the
provided ASSY BRACKET STACKING on the right side, and assemble the REAR
BRACKET (provided with the SKK-8K stacking kit) on the left side. Use the
screws provided with the SKK-8K stacking kit to fasten both brackets.
STEP 1. DO NOT TIGHTEN SCREWS COMPLETELY.
LOOSELY fasten two REAR BRACKETS at the back of the washer using the two
SCREWS-HEX HEAD (6002-001431) and WASHERS (DC60-00044A). SCREWS-HEX HEAD and
WASHERS are included in the SKK-8K stacking kit.
- Fasten the ASSY BRACKET STACKING on the right-side.
- Fasten the other REAR BRACKET on the left-side.
In case you already have a dryer stacked to a washer, and you are replacing the dryer with the new one, remove the old REAR BRACKET on the right side and replace with the provided ASSY BRACKET STACKING.
STEP 2.
Put the dryer on the washer, as shown in the figure. Leave a little space between the dryer and the bracket.
CAUTION
- To prevent noise, make sure the washer is level, and the dryer’s leveling legs are tightened up. (Stacking Kit: SKK-8K, for 27” models)
- For detailed instructions on stacking, see the “Stacking Kit Installation Instructions”.
- Make sure to keep the wire (of the ASSY BRACKET STACKING) away from the top of the washer before stacking the dryer.
STEP 3.
Follow the STEP 7 ~ STEP 10 of the ‘Stacking Kit Installation Instructions’
provided with the SKK-8K to assemble the bracket on the rear side of the
washer. Assemble the provided ASSY BRACKET STACKING on the right side and
assemble the REAR BRACKET (provided with the SKK-8K stacking kit) on the left
side. All the necessary parts are included in the stacking kit.
STEP 4.
Open the connector port cover on the dryer and the washer, connect the wire on
both ports, and then close the cover.
- Be careful not to damage the wire by the connector port cover.
- Do not pull the wire too hard to remove the connector from the port.
STEP 5.
There are two HOLDER WIRE pre-assembled to the wire. Attach each HOLDER WIRE to the dryer and the washer. Check and make sure the washer and the dryer are connected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>