BARTEC RS1000 Programmable TPMS Rite Sensor User Guide
- June 5, 2024
- BARTEC
Table of Contents
BARTEC RS1000 Programmable TPMS Rite
**Sensor User Guide**
Product Information
FCC and IC Notice
The RITE-SENSOR complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired function.
Warning: Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Prop 65 Warning
Cancer & reproductive harm www.P65warnings.com
Contents
The RITE-SENSOR® assembled with a rubber valve stem, optional aluminum valve
stem and anti-rotational pin.
Warranty
The RITE-SENSOR has a limited lifetime guarantee to be free from material and manufacturing defects. This warranty covers any defects in material or workmanship under normal use. Excluded from the warranty are normal wear and tear and defects due to improper installation and usage.*
Caution
- Any maintenance and repair work must be carried out by trained experts. Failure to do so may result in the failure of the TPMS sensor. The manufacturer does not assume any liability in case of faulty or incorrect installation of the product.
- Read the installation and safety instructions carefully, before installing the sensor.
- When the tire bead is initially broken, ensure the valve is on the opposite side of the wheel from the bead breaker blade. When a tire is removed or a sensor is serviced it is highly recommended to replace or service the sensor.
- A Snap-In sensor always requires the valve stem to be replaced.
- A Clamp-In sensor is properly serviced by replacing the valve nut/collar/core, rubber grommet and if necessary, the valve stem. It is very important to tighten the nut/collar to the correct torque of 35.5 in-lbs.
Assembly
The RITE-SENSOR comes assembled with a rubber valve stem. In some cases the aluminum valve stem is required or needed. First remove the rubber valve stem by unscrewing the fastener. Insert the aluminum stem into the sensor. Insert the anti-rotation pin into the hole at the base of the stem, just above the sensor body. Insert NEW fastener into stem and torque to 35.5 in-lbs (4Nm).
Programming
The RITE-SENSOR needs to be programmed BEFORE use. To program the RITE-SENSOR®
according to specific year, make and
model being serviced, follow the instructions on your Bartec Tech400Pro,
Tech500, Tech300Pro, or Tech400SD TPMS service tool. It is important to know
the precise application information to accurately program your RITE-SENSOR®
*The sensor valve is warranted for twenty-four (24) months, however if the tire is removed, the valve must be serviced to uphold the sensor lifetime warranty.
RITE-SENSOR with Rubber Valve Standard
Installation Guide
Deflate and Disassemble Tire and Wheel
Detach Sensor from Stem, Remove Stem and Inspect the Wheel
Assembly of RITE-SENSOR® with Rubber Valve Stem Fitted
Assembly of RITE-SENSOR® with Aluminum Valve Stem Fitted
Mount the tire to the wheel
Perform RITE-SYNC® using Bartec TPMS Tool
Print/Save Inspection Report
Program single RITE-SENSORS or sensors not being installed on a vehicle by using Bartec TPMS Tool
WARRANTY INFORMATION
To activate limited lifetime warranty, please complete the above section and send to: RITE-SENSOR Warranty, Bartec USA, LLC. 44231 Phoenix Drive, Sterling Heights, MI 48314. Attn: Customer Service. Or visit www.ritesensor.com to activate warranty
PROFESSIONAL INSTALLER INFORMATION:
CONSUMER INFORMATION:
RS1000UG
V1.3 December 2020
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>