MATCO TOOLS MICROJUMP2 Jump Starter And Power Bank Instructions

MATCO TOOLS MICROJUMP2 Jump Starter And Power Bank

MICROJUMP2 MICROJUMP2 JUMP STARTER AND POWER BANK

The MICROJUMP2 is not only a jump starter*. It is also a power bank for charging many every day devices like your mobile phone, tablet, media players, camera and other electronics. It also has a LED flashlight with three modes: standard, SOS, and strobe.

• For use on V6 gasoline engines and smaller. 2404237-17

WARNINGS: Read this entire manual before using this product. This unit is intended for use with 12V SYSTEMS ONLY. Use on any other system will void the manufacturer’s warranty.

• DO NOT use this unit in place of a vehicle’s battery.
• DO NOT connect positive and negative clamps to one another.
• DO NOT attempt to start a car for more than 30 seconds at a time. If the vehicle fails to start after three consecutive attempts, stop and allow the unit to cool for a minimum of five minutes to avoid potential overheating.
• DO NOT expose this unit or any of its components to water, extreme cold, extreme heat or prolonged high heat.
• DO NOT leave this unit unattended while in use or use in or around flammable objects.
• DO NOT use this unit if you notice damage and/or swelling.
• DO NOT modify or attempt to disassemble this unit or any components, as this will immediately render the warranty null and void and could cause unit damage, user injury, or even fire.
• DO NOT attempt to start a vehicle while the unit is being charged.
• ALWAYS make sure there is no corrosion or debris on the jump start cables plug-in before each use.
• DO NOT charge unit at below 32°F or above 90°F
• DO NOT leave clamps attached to vehicle battery after vehicle has been started. Remove immediately.
• DO NOT use attachments, cables, clamps, etc. not included with the unit or not approved by manufacturer.
• Doing so could cause damage to unit or even fire. ALWAYS dispose of batteries and electronic devices properly and according to all local regulations.

CAUTION: If damaged or used under extreme conditions the unit could potentially leak fluid. If this liquid comes in contact with skin, wash with mild soap and lukewarm water immediately. If liquid from unit comes in contact with your eyes, rinse with cold water for 10 minutes and seek medical attention.

Specifications:

• Model: MICROJUMP2
• Capacity: 29.6 Wh
• Input: 5V/2A
• Output: 5V/2.1A
• Lifespan: Approximately 1,000 cycles
• Weight (all components): 1.575 lbs.

Components
MICROJUMP2 power bank and jump starter unit Smart Cables, jump starting cables Charging cord

Functions and Features

Starting a vehicle

1. Begin by reviewing your vehicle’s owner manual for operating instructions. Make sure the unit is at approximately 25% charge. At least one indicator light needs to be illuminated. Connect the red POSITIVE (+) clamp to the POSITIVE (+) terminal of the battery. Connect the NEGATIVE (-) clamp to the NEGATIVE (-) terminal of the battery, or grounding stud.
2. Plug the blue connector of the SMART CABLES in to the JUMP STARTER CONNECTION PORT.
3. Start the vehicle.
4. Disconnect the SMART CABLES from the JUMP STARTER CONNECTION PORT.
5. Disconnect both of the clamps from the battery terminals.

Charging Devices

1. Connect the MICROJUMP2 to your depleted device by inserting your device’s charging cord into the standard USB CHARGING PORT.
2. Insert the other end into the device you would like to charge.
3. Press the POWER BUTTON.

Note: Never charge unattended and never charge near or around flammable objects.

Using the LED Flashlight

1. Hold the POWER BUTTON for three seconds to turn on the flashlight.
2. Press the POWER BUTTON again to switch to SOS mode and once more for strobe mode.
3. Hold the POWER BUTTON for three seconds to turn off the flashlight.

Charging the MICROJUMP2

1. Insert the Type-C end of the provided CHARGING CORD into the INPUT PORT of the MICROJUMP2.
2. Plug the standard USB end into a standard USB power source.
3. The INDICATOR LIGHTS will flash once charging is initiated.

LIMITED WARRANTY INFORMATION LIMITED WARRANTY

For repair or replacement, contact customer service at 1-800-537-1077. DO NOT SHIP UNTILYOU RECEIVE A RETURN MECHANDISE AUTHORIZATION (RMA) number from customer service at Horizon Tool, Inc.

NOTE: Save proof of purchase, such as a dated store receipt, to establish warranty period. Without a dated receipt, we will use the manufacturing date code. This warranty for the jump starter is extended to the original purchaser or user, and it covers defects in materials and workmanship for one year. For malfunction due to defects in materials or workmanship prior to 6 months from the purchase date, we will repair or replace the unit at our discretion after inspection.

NOTE  The battery is covered under separate terms. The battery will be prorated monthly, over one year, from the end of the first month to the end of the twelfth month.
This applies only to batteries which have not been misused or abused, Typical failure modes of misused or abused battery are melted terminals or signs of overcharging.

This warranty is invalidated if any of the following occurs, but not limited to this list:

• Failure to follow instructions in the User Manual
• Accidental or unreasonable use or misuse
• Mishandling
• Extended storage without recharging
• Repairs by unauthorized person or modification
• Normal wear or accident

This warranty is in lieu of all other express warranties. Horizon Tool, Inc. will not be liable for consequential or incidental damages. Some states do not allow limitations on warranties. In such case, the above limitation may not apply.

SERVICE ADDRESS Horizon Tool, Inc. 7900 Industrial Village Road Greensboro, NC 27409

NOTE: Whenever returning a product to this address, it must be packaged securely to avoid shipping damage. Horizon Tool, Inc. will not be responsible for any shipping or handling damage. Also, all postage or transportation must be prepaid.

CUSTOMER SERVICE CONTACT
Horizon Tool, Inc. Service Department
Tel: 1-800-537-1077
Fax: 1-800-537-1717
Email: info@horizon-tool.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>