DASH Orbit False Alerts With IC Realtime’s Latest Security User Guide
- June 5, 2024
- Dash
Table of Contents
DASH Orbit False Alerts With IC Realtime’s Latest Security
Using the Dash App
- Scan the QR code or search “IC Realtime” in the Google Play or App Store to download and install DASH App.
- Run the DASH App, and then register a new account if you do not already have one.
- Connect the camera to a power source.
- The camera LED indicator will flash green when it is fully booted on.
- With your mobile device connected to a 2.4 GHz band, add a camera by following the steps on the app.
Note: • Repeat step S for adding multiple cameras. If camera fails to to add or the WiFi connection is changed. Reset the camera and repeat step .
Camera Installation
Note: Make sure the mounting surface can hold at least lib. 
- Step 1 Use the guide to mark & drill holes for the drywall anchors.
- Step 2 Attach the mounting plate by drilling the provided screws into the anchors from step 1.
- Step 3 Attach the camera to the magnetic mounting plate,
What’s in the Box
- Camera xl
- Power Adapter xl
- Power Cable xl
- Hole Guide xl
- Mounting Plate xl
- Hardware Package xl
- QSG xl
Know your Orbit
LED Indicator Status Device
Status
Off: Powered
off/LED turned off Rebooting after r eset
Red light on: Booting,
Device malfunction
Greenlight flashing: Waiting for
network
Greenlight on: Operating
properly
Red light flashing: Network
connection failed
Green and Red lights flashing alternately: Firmware updating
Note: Press and hold the reset button for 10 s to reset the camera. The pattern of the LED indicator is included in the following table.
Regulatory Information
The regulatory information herein might vary according to the model you
purchased. Some information is only applicable for the country or region where
the product is sold.
FCC Information
CAUTION Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
FCC conditions:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- • This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired operation.
FCC compliance:
This equipment has been tested and found to comply with the limits for a
digital device, pursuant to part 15 of the FCC Rules. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communication.
- For class B device, these limits are designed to provide reasonable protection against harmful interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Privacy Protection Notice
As the device user or data controller, you might collect personal data of others such as face, fingerprints, car plate number, Email address, phone number, GPS and so on. You need to be in compliance with the local privacy protection laws and regulations to protect the legitimate rights and interests of other people by implementing measures include but not limited to: providing clear and visible identification to inform data subject the existence of surveillance area and providing related contact.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>