PHILIPS AZ700T CD Bluetooth Sound Machine User Guide
- June 5, 2024
- Philips
Table of Contents
AZ700T CD Bluetooth Sound Machine
AZ700T
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke
Philips N.V. and are used under license. This product has been manufactured by
and is sold under the responsibility of MMD Hong Kong Holding Limited. or one
of its affiliates, and MMD Hong Kong Holding Limited. is the warrantor in
relation to this product. AZ700T_37_QSG_V2.0
MUTE USB CD
BT AUDIO IN
TUNER
PAIRING
ALBUM/ PRESET
REPEAT SHUFFLE
DSC
SLEEP BACKLIGHT
DBB PROG
MUTE USB CD
BT AUDIO IN
TUNER
PAIRING
MUTE USB CD
BT AUDIO IN
TUNER
PAIRING
ALBUM/ PRESET
REPEAT SHUFFLE
DSC
SLEEP BACKLIGHT
DBB PROG
MUTE USB CD
BT AUDIO IN
TUNER
PAIRING
AC~MAINS
MUTE USB CD
BT AUDIO IN
TUNER
PAIRING
MUTE USB CD
BT AUDIO IN
TUNER
PAIRING
ALBUM/ PRESET
REPEAT SHUFFLE
DSC
SLEEP BACKLIGHT
DBB PROG
MUTE USB CD
BT AUDIO IN
TUNER
PAIRING
MUTE USB CD
BT AUDIO IN
TUNER
PAIRING
ALBUM/ PRESET
REPEAT SHUFFLE
DSC
SLEEP BACKLIGHT
DBB PROG
MUTE
BT
V4.2 120V~60Hz;
DSC
SLEEP BACKLIGHT
DBB PROG
100
1. To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. 2. A warning that batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. 3. where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable
CLASS 1 LASER PRODUCT
V4.2 4. Complies with 21 CFR 1040.10 and 1040.11 except for deviations
pursuant to Laser Notice No.50, dated June 24, 2007
MMD Hong Kong Holding Limited Units 1006-1007,10th Floor, C-Bons International Center,108 Wai Yip Street, Kwun Tong, Kowloon, Hong Kong
120V~60Hz;
FCC Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
100
changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: — Reorient or relocate the receiving antenna. — Increase the separation between the equipment and receiver. — Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. — Consult the dealer or an experienced radio/TV technician for help.
V4.2
FCC Radiation Exposure Statement: This equipment complies with FCC radiation expo-sure limits set forth for an uncontrolled environment and meets the FCC radio
frequency (RF) Exposure Guidelines. When using the product, keep a distance of at least 20cm from the product.
ISED Regulatory Compliance
120V~60Hz;
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1 )This device may not cause interference.(2)This device must accept any interference, including interference that may cause undesired operation of the device. L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :(1)L’appareil ne doit pas produire de brouillage; (2)L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
RF Exposure Compliance
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not
be co-located or operating in conjunction with any other antenna or transmitter.
100
ce matériel est conforme aux limites de dose d’exposition aux rayonnements FCC/IC énoncées pour un autre environnement.cet
émetteur ne doit pas être situées ou opérant conjointement avec toute autre antenne ou l’émetteur
L’appareil est conforme aux valeurs limites d’exposition au rayonnement fixées pour l’ic rs-102 pour les environnements non contrôlés.Le dispositif doit être installé et fonctionner à une distance d’au moins 20 cm entre le radiateur et votre corps.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>