Shenzhen Shunxinda Trading Q3571 MP5 Car Player User Guide

Car MP5 Player
Operation Manual

Preface:
In order to prevent injuries and fires, pis pay attention to the following Instructions:

• In order to prevent short circuits and so on, do not drop the metal objects In the device.
• If there is smoke or a peculiar smell on the device, pis turn off the power at once.

Pis does not make the device fail or have a strong collision. In order to prevent device failure, pis observe the following note:

• Pis do not Install the device In a place of strong sunlight, high temperature, high humidity, or dust.
  Pis replace the fuse which is the same specification. If you are using different specifications of the fuse, may cause the failure of the device

In order to prevent a short circuit, pis pull out the power wire when you replace the fuse.

• In order to be able at any time to deal with road and traffic conditions change. pis lower the volume when driving.
• PIA does not get the device wet when washing the ear, this may cause a short circuit, then fire or another failure will be caused.

Warning

1. Only connect the unit to n DC 12V power supply with negative grounding.
2. Never install the unit where the operation for safety driving is restrained.
3. Never use the video display function In the front when driving to prevent the violation of laws and regulations and also to reduce the risk of traffic accidents except using the rearview video camera.
4. Never expose the unit, amplifier, and speakers to moisture or water to prevent electronic sparks or fires.
5. Pis don’t change the fuse in the power cord without professional guidance; an improper fuse may cause damage to this using unit or even cause a fire.

Installation:

Tho unit installs for security, pis Install It refer to the following diagram description:

1. Pis make the unit In the proper place, connects the unit refers to the diagram and tests whether it works well or not.
2. Pis wrapped the connection line with insulation tape to ensure complete wiring after testing well.
3. Pis bend the hook of metal 1 and Insert the metal into the Instrument panel then fixed it.
4. Put the unit into a metal hook unit it locks.

General Features

7″ TFT HD Touch Swoon DT/FM/THUM MP5 Rearview Camera

• 7 Inch digital IF? Touch Screen
• With TF card Slot, With a USD 2.0 port
• 1080P Video Format
• Support the Audio playback format of MP3/WMANVAV/ MKV/FLAC/OGG/APE.
• Support the Video playback formal of RM/RMVS/DVD(V0B)/ VCD(DAT)/MPUMP2/DIVX/XVID/MP4/H283/1-1284/FLV/3GP/ SWF/AVI/ASF/MJPEG etc;
• MOSFET amplifier:80 watts x 4 max power output.
• FM Range’87.5MHz-108.00MHz(Europe)
• With Remote Control
• Power-off with auto-memory store function under radio or TF/USB mode
• Clock Function
• Mute Function
• BT Function
• Bass&TrubluiLliR channel stabilizer
• Aux In Function
• Rearview camera Function
• Video-Input Function

Basic operation

1. when you reverse the rearview function. reversing video signal from the corresponding port input connection back lino, whop reversing will automatically switch to reversing visual slate.
2. Audio/Vadlo input(optional) Connect audioNedlo lines, press Mode can select AUX-2 state.
3. BlueTooth functions only for the unit with Bluetooth

After connecting the mobile, the Bluetooth symbol turn green means the connection Is ok, when calls come in will enter into the Bluetooth interface automatically, press answering the phone, and press” “hanging up the phone.

Wire Diagram

Pis checks the speaker lino carefully before Installation. If tiny grounding or touching, pls connect again or the will ha burn.

Specification

SNR…………………………………………………………………………………….. 65dB
Frequency response…………………………………………….. 201-12-20KHz
Loudspeaker impedance …………………………………………………… 40_80
The maximum output power …………………………………………… 4060W
Tone Control ………………………………………………….Bass+/-7dB(100Hz) Treblo+/-7dB(100Hz)
FM
FM frequency ……………………………………………….. 87,5MHz-108MHz
Sensitivity ……………………………………………………………………….. 25dB
Selectivity ………………………………………………………………………… 60dB
Separation ……………………………………………………………………….. 35dB

Remote Control Description

1. Power switch
2. ◀ Right
3. Mode mach
4. Laet seep
5. USB/SD
6. Volume –
7. Band/Automatic/Station search.
8. Digital key
9. ▲up
10. Menu
11. Confirm/Play/Pause
12. ▶ Left
13. ▼ Under
14. Next long
15. Choice
16. Volume+
17. Answer the phone
18. Hang up

Steering wheel buttons Learning Function

1. After connecting the wires, pis open the UI, choose the button which you need, eg: ****
2. After connecting the wires, Press ****the CI button, and it will show the UI which you need. Press “Reset to enter into the reset function
3. Press Confirm the button to prove the setting successfully, then, Exit the interface

Front Panel

1. **** Last song
2. **** Next song
3. PowerPress is a long time to turn on/off Press it. Short time to enter into Switch mode.
4. Knob Button: Adjust VOLE/VOL-, Press its short time to enter into BASS/TRE/BAL/EQ/LOUD/VOL /BRIGHT
5. TF
6. AUX
7. RES
8. USB
9. MIC
10. IR
11. Volume+/Volume-
12. Clock: Press it to adjust Date Time
13. Bright: Press it to enter Into Bright mode
14. BT: Press It to enter Into BT mode
15. Home
16. Radio
17. Music
18. Movie
19. Photo 20.Explorer
20. Bluetooth
21. AUX in
22. Setting

HOME

RADIO

MUSIC

MOVIE

PHOTO

BLUETOOTH

SETTING

BLUETOOTH

|
---|---

FCC Statement

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>