YPHIX LED Portia 1 24V Installation Guide
- June 3, 2024
- YPHIX
Table of Contents
YPHIX LED Portia 1 24V Installation Guide
Outline Dimension
Bom
- Front cover
- Housing
- Clip spring
- Cable gland
Note: The drawing was show a general introduction to this description. When the discrepancy between the actual product and drawing, please all to the actual products.
Features
- This product is a high power LED inground light.
- The standard color temperature of warm white is in range 2700-3200k.
- The standard input voltage is 24VDC.When you install the product, please check the date label on the product and the wire.
- When using low voltage light fixture, please prepare powerful power supply or 24VDC output transformer. Total demand of power is according to total power consumption +total power of cable impedance consumption. When installation, always work with technician or install by technician.
- The main material of this product is aluminum, surface coating is only suitable for natural environment, do not install this product near the sea water or in the environment which is high salty or Hight acid.
- This is IP67 grade product.
- Applicable environment temperature: -20℃<fixture<+40℃.
Installation
-
Install the sleeves on the ground, the top side should on the same level with the ground surface, cable need to go through the sleeve.
-
Connect the cable with the light keep enough length for the maintain.
-
Put the light fixture into the sleeve.
Note: The thickness of the gravel must be greater than 25cm.
Wiring Diagram
Low voltage single color fitting: use external power supply, the input voltage of power supply must be consistent with the requested input voltage of the fitting, as the fitting is constant voltage input type. he power consumption of power supply must be decided by installer according to the requirements from the site.
Example of wiring:
24VDC:circiut of product.
Explanations: the transmits circuit of the whole group depends on the circuit of junction boxes. the max. current depends on the max. load of power cable between the junction boxer, but it is not related to the max. load current of power cable of the fitting. The outer diameter of cable between the junction boxes is limited by the max. outer diameter of speedy plug, the max. allowed outer diameter is 10mm.
Specifications
Material specifications
- HOUSING: 12# Die-casting dark grey powder coated aluminum T=60-80µm.Adhesion of ISO class 1/ASTM class 4B
- FRONT COVER: Hard chrome plated stainless steel SUS 316#
- LOADING CAPACITY: >2000kg
- GASKET: Molding shaped silicone seal
- OPERATING TEMPERATURE: -20˚C~40˚C
- POWER CABLE: H05RN-F 2X1.0mm2 L=0.5m
- MOUNTING SLEEVE: 062# ABS plastic
- DIMMABLE SUPPORT: Triac PWM 1-10V Dali
Electrical parameters
Item No.| Light source| Input voltage (V)| Typical operating current(mA)|
Typical Consumption(w)| Typical luminance(1 m)| IK rate
---|---|---|---|---|---|---
1E2XA0154| 1x2W| 24V DC| 24V = 110| 24V = 2.6| 4| 10
2E2XA0154| 1x2W| 24V DC| 24V = 110| 24V = 2.6| 7| 10
4E2XA0154| 1x2W| 24V DC| 24V = 110| 24V = 2.6| 8.38| 10
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>