Razor W13111701003 Electric Party Pop Electric Tekno Installation Guide
- June 5, 2024
- Razor
Table of Contents
Razor W13111701003 Electric Party Pop Electric Tekno
Required Tools
- Phillips screwdriver
WARNING: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.
- Using a Phillips screwdriver, remove ten (10) screws from the bottom of the unit.
- Flip the unit over and lift the deck being careful not to pull the wires from the sensor pad. Set the deck cover aside.
- Locate and disconnect the Battery from the controller.
- Using a Phillips screwdriver, remove three (3) screws from the battery holder and carefully remove the battery.
- Reverse the steps.
- ATTENTION: Charge battery 4 hours before using.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>