eufy L20-L40 Automatically Track Humans Camera User Guide
- June 5, 2024
- Eufy
Table of Contents
QUICK START GUIDE
SoloCam L20 / L40
PRODUCT OVERVIEW
1. Camera Lens
2. Motion Sensor
3. Photosensitive Sensor| 4. LED Indicator
5. Microphone
6. Mounting Hole
---|---
7. SYNC Button
8. Type-C Charging Port| 9. Speaker
---|---
CHARGING SOLOCAM
Battery-powered
Charging | Solid blue |
---|---|
Fully charged | Off |
SETTING UP SOLOCAM
Download the App and Set up the System
-
Download and install the eufy Security app, and sign up for an account.
-
Follow on-screen instructions to add your SoloCam.
MOUNTING SOLOCAM
Select a Location
SoloCam L20 / L40 can be mounted on a wall or ceiling. Select a location where
you can get the desired view. We recommend hanging it 7-10 ft (2-3 m) above
the ground.
Mount SoloCam L20 / L40
SoloCam L20 / L40 can be mounted both outdoors and indoors.
-
Turn the knob of the mounting bracket counterclockwise to loosen and disassemble it.
-
Place the mounting bracket against the wall. Drill holes with a 15/64 inch (5.99 mm) drill bit, then insert the anchors into the holes; anchors are necessary for walls that are made out of hard materials such as concrete, brick, or stucco.
-
Firmly screw the knob of the mounting bracket into the mounting hole of SoloCam.
-
Hold and screw SoloCam to the mounting bracket. Rotate SoloCam to adjust the view and check it using the live stream which you can access in the eufy Security app.
SoloCam L20 / L40 can be also installed on the ceiling. Follow the steps 1-4
mentioned above to install it.
Tips:
For troubleshooting, check Help on the eufy Security app. Refer to the app
page for LED indicator status.
NOTICE
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and,if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The
device can be used in fixed/mobile exposure condition. The min separation
distance is 20 cm.
Notice: Shielded cables
All connections to other computing devices must be made using shielded cables
to maintain compliance with FCC regulations.
The following importer is the responsible party.
Company Name: POWER MOBILE LIFE, LLC
Address: 10900 NE 8TH ST, STE 501, BELLEVUE, WA 98004
Telephone: 1-800-988-7973
IC Statement This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:(1) this
device may not cause interference, and(2) this device must accept any
interference, including interference that may cause undesired operation of the
device.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
IC RF Statement
When using the product, maintain a distance of 20cm from the body to ensure
compliance with RF exposure requirements.
Customer Service
Warranty
12-month limited warranty
Call Us United States +1 (800) 988 7973 Mon-Fri 9AM-5PM (PT)
United Kingdom +44 (0) 1604 936 200 Mon-Fri 6AM-11AM (GMT)
Germany +49 (0) 69 9579 7960 Mon-Fri 6:00-11:00
Email Us Customer Support: support@eufylife.com
Anker Innovations Limited Room 1318-19, Hollywood Plaza, 610 Nathan Road,
Mongkok, Kowloon, Hong Kong
| @EufyOfficial
---|---
| @EufyOfficial
| @EufyOfficial
Anker Innovations Limited. All rights reserved. eufy Security and eufy Security Logo are trademarks of Anker Innovations Limited, registered in the United States and other countries. All other trademarks are the property of their respective owners.
51005002777 V01
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>