FUJIFILM XF 18-120mm f-4 LM PZ WR Standard Zoom Lense Owner’s Manual

FUJIFILM XF 18-120mm f-4 LM PZ WR Standard Zoom Lense

For Your Safety

Be sure to read these notes before use

Safety Notes

Thank you for your purchase of this prod-uct. For repair, inspection, and internal testing, contact your Fujifi lm dealer.

• Make sure that you use the lens correctly. Read these safety notes and the camera Owner’s Manual carefully before use.
• After reading these safety notes, store them in a safe place.

About the Icons

The icons shown below are used in this document to indicate the severity of the injury or damage that can result if the in-formation indicated by the icon is ignored and the product is used incorrectly as a result.

WARNING This icon indicates that death or serious injury can result if the information is ignored
CAUTION This icon indicates that personal injury or material damage can result if the information is ignored

The icons shown below are used to indicate the nature of the instructions which are to be observed.

****Triangular icons tell you that this information requires attention (“Important”).
Circular icons with a diagonal bar tell you that the action indicated is prohibited (“Prohibited”).
Filled circles with an exclamation mark indicate an action that must be performed (“Required”).

WARNING

• Do not immerse in or expose to water. Failure to observe this precaution can cause a fi re or electric shock.
• Do not disassemble. Failure to observe this precaution can cause fi re, electric shock, or injury due to product malfunction.
• Should the case break open as the result of a fall or other accident, do not touch the exposed parts. Failure to observe this precaution could result in electric shock or in injury from touching the damaged parts. Remove the camera battery immediately, taking care to avoid injury or electric shock, and take the product to the point of purchase for consultation.
• Do not place on unstable surfaces. The product may fall, causing injury.
• Do not view the sun through the lens or camera viewfinders. Failure to observe this precaution can cause permanent visual impairment.

CAUTION

• Do not use or store in locations that are exposed to steam, or smoke or are very humid or extremely dusty. Failure to observe this precaution can cause fi re or electric shock.
• Do not leave in direct sunlight or in locations subject to very high temperatures, such as in a closed vehicle on a sunny day. Failure to observe this precaution can cause a fire.
• Keep out of the reach of small children. This product could cause injury in the hands of a child.
• Do not handle it with wet hands. Failure to observe this precaution can cause electric shock.
• Keep the sun out of the frame when shooting backlit subjects. Sunlight focused on the camera when the sun is in or close to the frame can cause fi re or burns.
• When the product is not in use, replace the lens caps and store out of direct sunlight. Sunlight focused by the lens can cause fi re or burns.
• Do not carry the camera or lens while they are attached to a tripod. The product can fall or strike other objects, causing injury.

Tested To Comply With FCC Standards

FOR HOME OR OFFICE USE FCC Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a cir-cuit diff erent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• You are cautioned that any changes or modifi -cations not expressly approved in this manual could void the user’s authority to operate the equipment.
  Notes on the Grant: To comply with Part 15 of the FCC Rules, this product must be used with a Fujifi lm-specifi ed ferrite-core A/V cable, USB cable, and DC supply cord.

For Customer In Canda
CAN ICES-3 (B)/NMB-3(B)
CAUTION: This Class B digital apparatus complies with Canadian ICES-003.

IMPORTANT SAFETY INSTRUCTIONS

• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not use this apparatus near water (excluding waterproof products).
• Clean only with a dry cloth.
• Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifi ers) that produce heat.
• Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
• Only use attachments/accessories specifi ed by the manufacturer.
• Unplug this apparatus during lightning storms or when unused for long periods of time.
• Refer all servicing to qualifi ed service personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

Disposal of Electrical and Electronic Equipmentin

In the European Union, Norway, Iceland and Liechtenstein:

This symbol on the product, or in the manual and in the warranty, and/or on its packaging in- dicates that this product shall not be treated as household waste. Instead it should be taken to an applicable collection point for the recycling of electrical and electronic equipment.

By ensuring this product is disposed of correctly, you will help prevent potential negative conse-quences to the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
The recycling of materials will help to conserve nat-ural resources. For more detailed information about recycling this product, please contact your local city offi ce, your household waste disposal service or the shop where you purchased the product.

In Countries Outside the European Union, Norway, Iceland and Liechtenstein: If you wish to discard this product, including the batteries or accumulators, please contact your local authorities and ask for the correct way of disposal.

U.K. Importer:
FUJIFILM UK Limited
Fujifi lm House, Whitbread Way, Bedford, Bedfordshire, MK42 0ZE, United Kingdom

EU Importer:
FUJIFILM Electronic Imaging Europe GmbH Fujistrasse 1 47533 Kleve, Germany

Before Using This Product

The lens may not perform as expected and some features may not be available with out-dated lens or camera fi rmware. Be sure to up-date the lens and camera fi rmware to the latest versions. Instructions on viewing fi rmware ver-sion information and updating fi rmware are available from the following website:
https://fujifilm-x.com/support/download/firmware/
If you do not have access to a computer, sup-port is available from the local distributor listed in the “FUJIFILM Worldwide Network” material provided with your camera.

Product Care

• When using a lens hood, do not pick up or hold the camera using only the hood.
• Keep the lens signal contacts clean.
• Use a blower to remove dust and lint from the glass surfaces of the lens or fi lter. To remove smudges and fi ngerprints, apply a small amount of lens cleaner to a soft, clean cotton cloth or lens-cleaning tissue and clean from the center outwards using a circular motion, taking care not to leave smears or touch the glass with your fi ngers.
• Never use organic solvents such as paint thinner or benzene to clean the lens.
• Attach the front and rear caps when the lens is not in use.
• Store the lens and fi lter in cool, dry locations to prevent mold and rust. Do not store in direct sunlight or with naphtha or camphor moth balls.
• Keep the lens dry. Rusting can cause irrepa-rable damage. Wipe off rain and water drop-lets.
• Leaving the lens in extremely hot locations could cause damage or warping.

Parts of the Lens

XF18-120mmF4 LM PZ WR

1. Lens hood
2. Mounting marks
3. Focus ring
4. Zoom ring
5. Zoom/focus control ring
6. Mounting marks (focal length)
7. Zoom buttons
8. Z/F (zoom/focus) button
9. Lens signal contacts
10. Front lens cap
11. Rear lens cap
12. The lens mount includes a rubber ring to ensure that the lens remains dust- and splash-proof. The ring can be replaced for a fee at any Fujifi lm service center.

Lens performance and supported features vary with the camera used. Compatibility data for this lens are available from:
https://fujifilm-x.com/global/support/compatibility/lenses/

Attaching the Lens

See the camera manual for information on attaching and removing lenses.
This product is for use exclusively with the FUJIFILM X mount. It is not compatible with the G mount or with X mount fi lm cameras.

Removing the Caps

Remove the caps as shown.

Attaching the Hood

When attached, lens hoods reduce glare and protect the front lens element.

Supplied Accessories

• Front lens cap
• Rear lens cap
• Lens hood
• Lens wrapping cloth

Aperture
See the camera manual.

Zoom

Zoom can be adjusted using the zoom/focus control ring, the zoom buttons, or the zoom ring.
Adjusting zoom while the lens is wet makes it easier for water to fi nd its way inside the lens. Wipe any water from the lens before adjusting zoom.

The Zoom/Focus Control Ring
Rotate the zoom/focus control ring to zoom in or out using powered zoom. The zoom speed is proportional to the speed with which the ring is rotated.

• To switch role of the the zoom/focus control ring from focus to zoom or vice versa, press the Z/F (zoom/focus) button.
• Depending on the camera, you may be able to assign other roles to the Z/F button. See the camera manual for more information.

The Zoom Buttons

Press a zoom button to zoom in or out at a steady speed using powered zoom. Zoom ends when the button is pressed a second time.

• Depending on the camera, you may be able to adjust the zoom speed or assign other roles to the zoom buttons. See the camera manual for more information.

The Zoom Ring

Rotate the zoom ring to zoom in or out manually.

Specifications

• Improvements may result in unannounced changes to specifi cations and appearance.

• Owing to how this lens is constructed, the “Distance indicator” displayed by the camera may in some cases diff er from the actual
  focus distance. Use the “Distance indicator” as a guide only.

• This lens uses linear motors to ensure fast and accurate autofocus while maintaining the highest image quality. When the camera is turned off , the lens is disconnected from the camera body, or the playback feature is turned on, there may be an audible sound and slight physical vibration due to the linear motor’s magnets being disengaged. This is perfectly normal and will not negatively affect image quality or lens performance.

References

• Compatibility:lenses | FUJIFILM X Series & GFX – Global
• 対応情報：レンズ | 富士フイルム Xシリーズ & GFX
• カメラ | FUJIFILM X Series & GFX - Japan
• Camera | FUJIFILM X Series & GFX - UK

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>