NORDOST QNET Stand Network Switch Instruction Manual

June 12, 2024
NORDOST

NORDOST QNET Stand Network Switch Instruction Manual
NORDOST QNET Stand Network Switch

QNET STAND

Easily support your QNET NETWORK SWITCH with Sort Kones for optimum performance with resonance control.

COMPONENTS

CENTER PIEC

LEGS (x3)

RING

RING

ASSEMBLY

Place center piece flat on a table with the pin side up.

Slide 3 legs onto pins with the slot for the rubber gasket and the Sort Kone depressions facing down
Assembly Instructions
Assembly Instructions

Carefully flip the stand over so that the legs do not slide off.
Assembly Instructions

With the grooves facing up, take the rubber ring and stretch it with both hands so that it can snap into the groove on one of the legs.

Repeat with the second leg, and then the third.
Assembly Instructions

ATTACHING

Lay the QNET upside down (with the vents facing down) on a flat surface. Lay the Stand on it so the legs fall symetrically, or approximately where you would like them.
ATTACHING Instructions

Hook two of the legs onto the edge of the unit and stretch the third so that it can snap on and secure the Stand to the QNET.
ATTACHING Instructions

FINISHING

Adjust so that the spaces between the legs and the center piece are about even.
FINISHING

Flip the unit over and set on three Sort Kones so the tips fit into the depressions.
FINISHING

See www.nordost.com/downloads.php
for more language options

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals