eeLink GPT19 GPS Tracker User Guide
- June 5, 2024
- eeLink
Table of Contents
eeLink GPT19 GPS Tracker
Turning your tracker on
To turn your tracker on, remove the top cover and make sure the switch is in the ON position. Your tracker may have been shipped turned on.
Placing your tracker
Your tracker has a built-in magnet. Place the tracker in any location that is not surrounded by metal (it can’t get a GPS signal when surrounded by metal). Ideally, the tracker is placed facing up toward the sky, however, this is not required.
Download the tracking app
Download the mobile app from the App Store or Play Store by searching for“Keelinktech”. You can also track from any web browser at Sky200.com
Login with email and password
Login to the app with your email address and the password you used when you purchased the tracker.
Sending commands to the tracker
You can configure your tracker by sending commands via the mobile app.The tracker will only respond to commands for few minutes after it has just been turned on or when it wakes up to report it’s location at it’s scheduled time.When you send a command and it is successfully received, the tracker will always reply with “OK” or a confirmation message.
Tracker reporting frequency
By default, the tracker will report it’s location every 24 hours and the
battery will last up to 5 years. The report frequency is configurable in the
app.To change the report frequency go to Commands > new command > Change
report frequency.Note that increasing the report frequency will decrease the
battery life.
The tamper sensor
The tamper sensor on the back of the tracker can send you an alert via text
message if the tracker is removed.To use this feature, you will need to send
two commands in the app. Set your cell phone number in the app by going to
Commands > Set SOS number.Also send the “Enable tamper button” command.
Tamper sensor and battery life
If the tamper sensor is triggered by removing the tracker, it will enter
into alert mode and report it’s location continuously for 30 minutes.Repeated
or accidental triggering of the tamper sensor can drain the battery quickly.
If you accidentally trigger the tamper sensor you can send the“Cancel removal
alarm” command to prevent draining the battery.
GPS positions vs Cell Tower positions
If your tracker reports a position with a light blue circle around it, this
indicates it is the location of the cell tower it’s connected to. You will get
an exact GPS fix when the tracker gets a better view of the sky. Try a new
spot or take the tracker outside.
Setting up alerts
To be notified if your tracker enters or exits an area, create a geofence.
In the mobile app, click Geofences > New Geofence. Give your new geofence a
name, address and size. Note that a geofence will only be triggered when the
tracker wakes up at it’s next scheduled time.
Troubleshooting
If you have a question or problem, we can help. Learn more about your tracker’s features, watch tutorial videos and ask questions at eelinktech.com /contact-us
Replacement battery
You can purchase a replacement battery for the. Questions? We’re here to
help! eelinktech.com/contact-us apple@eelinktech.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>