Aluratek AMAP01F Hepa H13 with PM2.5 Monitor Air Purifier User Guide
- June 5, 2024
- Aluratek
Table of Contents
HEPA H13 with PM2.5 Monitor Air Purifier
Quick Start Guide
Model AMAP01F
qsg Q10607 Copyright © 2022 Aluratek, Inc.
All Rights Reserved.
Package Contents
Your order has been carefully packaged and inspected. The following accessories should be included in your package. Please inspect the contents of the package to ensure that you have received all items and that nothing has been damaged. If you discover a problem, please contact us immediately for assistance.
Product Highlights
Operation
-
Filter Installation
-
Remove the air inlet cover
-
Remove the filter
-
Remove the plastic bag from the filter and reinsert
-
Replace the air inlet cover
Purifier Instructions
After the purifier is plugged into a wall outlet, you will hear a single beep
with the display lights up for a second, then it will go to standby mode where
the display will be off with the power button lights up in red.
Air Quality indicator:
Green means good air quality
Yellow means moderate air quality
Red means bad air quality.
Power
To power on the purifier, press the power button, the display will light up
and the purifier will enter auto mode.
Timer
When the purifier is on, you can press the timer button to set the timer
between 1-8 hours. You can verify the timer is set when you see the timer icon
lit on the display. The timer can be cancelled by pressing and holding the
timer button for about 3 seconds.
Speed
You can change the speed of the fan by pressing the fan icon to change
between auto (A), slow (1), medium (2), fast (4) and sleep (SLE).
Sleep
For Sleep mode, the fan speed will change to slow with the display turned
off except the sleep icon. To exit sleep mode, just touch the screen and
change the fan speed to other settings.
Reset
When the filter reminder icon is lit, please change the filter. Once the
filter is replaced, during standby mode, press and hold the filter button to
reset the filter life counter.
Power OFF
To power off the purifier, press the power button, the display will turn off
and the power button will light up in red.
Filter maintenance
This purifier uses a Hepa Carbon filter. It is suggested to be replaced every
two months.
After a run time of 1500 hours, the purifier’s replacement filter icon will
light up.
- Place the filter in a ventilated place
- Do not expose to excessive sunlight
- Do not wash the filter with water
- Unplug the power plug before replacing the filter, cleaning and maintenance
- Do not operate with the filter removed as this may cause equipment failure
- Unplug the power cord when the purifier is idle for a long period of time
Radio and TV Interference Statement
WARNING!!! This equipment has been tested and found to comply with the
limits of a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by whatever measures may be required to correct
the interference.
Technical Support and Warranty
If you need further assistance, please contact the Aluratek support department
for troubleshooting prior to returning this device.
E-mail: support@aluratek.com
Web: www.aluratek.com/helpdesk
Local (Irvine, CA): 714-586-8730
Toll free: 1-866-580-1978
Aluratek warrants this product against defect in material or workmanship for 1
YEAR from the date of purchase.
For more information, please visit: https://aluratek.com/warranty-return-
policy
You can register your product online at: https://aluratek.com/product-
registration