EPSON OT-CU40 Color Inkjet Label Printer User Manual
- June 5, 2024
- Epson
Table of Contents
EPSON OT-CU40 Color Inkjet Label Printer
OVERVIEW
CAUTION
- Do not subject the auto-cutter unit to impact by dropping or bumping it. Doing so may cause the unit to stop operating normally.
- Do not touch the movable blade of the auto-cutter. Doing so may result in injury.
- Store the cutter in a place out of reach of children.
How to Replace the Unit
- Turn off the printer and unplug the power cable from the power outlet.
- Open the maintenance box cover.
- Open the front cover.
- Loosen one screw with a Phillips screwdriver and then remove the auto-cutter cover set.
- Disconnect the connector of the auto-cutter unit from the printer.
- Loosen two screws with a Phillips screwdriver and then remove the auto-cutter unit.
- Install the replacement auto-cutter unit and secure it with two screws.
- Connect the connector of the auto-cutter unit to the printer.
- Attach the auto-cutter cover set and then secure it with one screw.
- Close the front cover.
- Close the maintenance box cover.
- Plug the power cable into a power outlet and then turn on the printer.
- Select the following menu on the operation panel to reset the counter of the auto-cutter. [Menu] – [Printer Status/Print] – [Auto Cut Counter] – [After Replacement]
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>