URBAN EXTREME TWS530 Wireless Earbuds User Guide
- June 5, 2024
- Urban Extreme
Table of Contents
EXTREME TWS530 Wireless Earbuds
User Guide
Wireless 5.0More compatible
Compatible with Apple IOS and Android smartphones Rich functions, one-button
control
L / R Short press………………………….Play/ Paus /Answer/ Hang-up
L / R Long press 2 ……………………………… In the boot state: Wake up Siri seconds
In the off state: Power on
L / R Long press4seconds …………………………………Power OFF
R Double click: previous song,……………………………………Three clicks: volume +
L Double click: next song ………………………………………………Three clicks: volume –
Easy pairing connection
-
The earphone is taken out of the package and placed in the charging compartment. The earphone is charged and activated, and the red light is on.
-
The headphones are taken out of the charging bin, the host red and blue lights alternately flashing, and the blue lights slowly flashing, that is, the pairing of ears is successful.
-
Open the phone Bluetooth Search Bluetooth name: TWS 530 Click Connect
Note: If the left and right headset do not connect within 1 minute, the headset will enter standby mode, if necessary please turn off the headset and follow the above steps to connect. -
After the headset is used put it directly into the charging box and the headset turns off.
-
To use the headset again, simply remove the headset from the charging box.
The headset will automatically complete the binaural pairing and connect the phone.
Charging schematic
Up to
Call! Play: about 5 Standby: about 150 hours 4 times: Mobile charging
Charging box
When charging: The screen is always on Full power: white light is always on
Charging time: about 1 hour
Headset
When charging: red light is always on Full power: red light turning blue
light Charging time: about 1 hour
Note: When charging the product charging box, please use our standard
charging cable, a 5V/ 1A charger.
Special Note: Do not use more than 5V/ 1 A fast charge charger, so as not to
damage the charging box!
Wear schematic Product schematic diagram
Packing List
- Bluetooth headset (left and right)
- Headset power box
- USB charging cable
- User’s Guide
- Beautiful packaging
Product specifications
Product Name: TWS 530
- Bluetooth connection name: TWS 530
- Bluetooth version:5.0
- Power Input: DC 5V
- Headset Battery capacity: 3.7V/ 50mAh
- Call/ play time: about 5 hours (Hours)
- Charging time: about 60 minutes (Min)
- Charge box battery capacity: 3.7V/ 350 mAh
- Support agreement: HSP / HFP /A2DP / AVRCP
- Sensitivity: 120 ± 5dB
- Frequency response range: 20-20000Hz
- Impedance: 160
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirements.