TEAM TECH Jeep JK Keypad Mounting Panel for SP-8100 8 Switch Panel Power System Installation Guide
- June 3, 2024
- TEAM TECH
Table of Contents
JK Keypad Mounting Panel for
SP-8100 8 Switch Panel Power System
Installation Guide
Jeep JK Keypad Mounting Panel for SP-8100 8 Switch Panel Power System
-
Temporarily upper interior above the rear while loosening the wiring attached remove the r trim piece view mirror the factory to it.
-
Continue running the SP-8100 wiring harness from the engine bay area to the area above the h rear view mirror at the TTO Switch Housing
-
Cut out and center template over the interior trim piece that was located above the rearview mirror
-
Drill two 9/64″ holes as indicated with the template. Then drill a,/2″ hole in the center of the two 9/64″ holes using an I/2″ UNI BIT. This hole is for the wiring to transfer through
-
Attach the Switch-Pro keypad bezel into the TTO housing and screw/lock in place using the two SP-8100 metal brackets.
freaky FreCIRIZiks
-
This is what you should see at this point. Ready to mount the interior trim back into the Jeep.
-
Congratulations You have completed the housing mounting portion of the installation. Any questions please call 720-460-1403 or email us at sales@teamtechoffroad.com
www.TeamTechOffroad.com
sales@teamtechoffroad.com
30403 Kings Valley Dr, Suite 1-113 Conifer CO,
80433720-460-1403
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>