IKEA 404.432.27 HUTTRA Integrated Fridge Instruction Manual
- June 12, 2024
- Ikea
Table of Contents
HUTTRA
404.432.27 HUTTRA Integrated Fridge
Product description
- Glass shelves
- Rating plate (at the side of crisper drawer)
- Crisper drawer
- Thermostat control knob/light
- Dairy lid / Dairy compartment
- Adjustable door balcony
- Metal wire and bottle divider
- Bottle balcony Freezer compartment (marked with the symbol for storing fresh food, frozen food and making ice cubes)
- Ice cube tray
- Low Temperature compartment door
Characteristics, technical data and images may vary
Accessories
First Use
Connect the appliance to the mains power supply.
The ideal temperatures for preserving food have already been set at the
factory (3-5/MED).
Note: After switching the appliance on, it will be necessary to wait for
2 to 3 hours before a temperature suitable for a standard appliance load is
reached.
Important!
This appliance is sold in France. In accordance with regulations valid in
this country it must be provided with a special device (see figure) placed in
the lower compartment of the fridge to indicate the coldest zone of it.
Controls
Refrigerator and freezer operation
The appliance’s refrigerator compartment features a control panel with LED
lights. A different temperature can be set using the C button as shown in the
figure.
The three green LED indicators indicate the refrigerator compartment set
temperature. The following adjustments are possible:
Set temperature
High (least cold)
Medium-high
Intermediate
Medium-low
Low (coldest)
To avoid food waste, please refer to the recommended setting (Intermediate),
and storage times found in the user manual.
Stand-by
Press the C button for 3 seconds to deactivate the appliance (the control
panel and lights remain off). Press the button again briefly to reactivate the
appliance.
Note: This operation does not disconnect the appliance from the power
supply.
Note: the ambient temperature, frequency of door opening and position of
the appliance can affect the temperature inside the two compartments. These
factors must be taken into account when setting the thermostat.
A Led light
B Refrigerator compartment temperature
C Button for temperature regulation and Stand-by function LED light
LEDs last longer than traditional light bulbs, improve internal visibility and
are environmentally friendly.
Refrigerator compartment
Defrosting of the refrigerator compartment is completely automatic.
The formation of water droplets on the rear internal wall of the refrigerator
compartment indicates that the automatic defrosting is underway.
The defrost water automatically runs into a drain outlet and then into a
container from where it evaporates.
Caution! The refrigerator accessories must not be placed in a dishwasher.
Freezer compartment
This appliance is a refrigerator with a star freezer compartment.
Packaged frozen food can be stored for the period of time indicated on the
packaging.
Once defrosted, food must be used within 24 hours.
To avoid food waste, please refer to the recommended setting (MED), and
storage times found in the user manual.
Installation
The appliance must be handled and installed by two or more persons – risk of
injury. Use protective gloves to unpack and install – risk of cuts.
Installation, including water supply (if any), electrical connections and
repairs must be carried out by a qualified technician. Do not repair or
replace any part of the appliance unless specifically stated in the user
manual. Keep children away from the installation site. After unpacking the
appliance, make sure that it has not been damaged during transport. In the
event of problems, contact the dealer or your nearest Aftersales Service. Once
installed, packaging waste (plastic, styrofoam parts etc.) must be stored out
of reach of children – risk of suffocation. The appliance must be disconnected
from the power supply before any installation operation – risk of electric
shock. During installation, make sure the appliance does not damage the power
cable – risk of fire or electric shock. Only activate the appliance when the
installation has been completed.
Be careful not to damage the floors (e.g. parquet) when moving the appliance.
Install the appliance on a floor or support strong enough to take its weight
and in a place suitable for its size and use. Make sure the appliance is not
near a heat source and that the four feet are stable and resting on the floor,
adjusting them as required, and check that the appliance is perfectly level
using a spirit level. Wait at least two hours before switching the appliance
on, to ensure that the refrigerant circuit is fully efficient.
WARNING: When positioning the appliance, ensure the supply cord is not
trapped or damaged.
WARNING: To avoid a hazard due to instability, positioning or fixing of
the appliance must be done in accordance with the manufacturer instructions.
It’s forbidden to place the refrigerator in such way that the metal hose of
gas stove, metal gas or water pipes, or electrical wires are in contact with
the refrigerator back wall (condenser coil).
To guarantee adequate ventilation, leave a space on both sides and above the
appliance. The distance between the rear of the appliance and the wall behind
the appliance should be 50 mm, to avoid access to hot surfaces. A reduction of
this space will increase the Energy consumption of product. Please remove the
power cord from condenser hook during installation before connecting product
to power supply.
When contacting our Service Provider, please state the codes provided on your
product’s identification plate. The model information can be retrieved using
the QR-Code reported in the energy label. The label also includes the model
identifier that can be used to consult the https://eprel.ec.europa.eu
database portal.
Inspection check list
Please follow the inspection checklist before using your appliance.
If any answer is NOT please follow the relevant action.
Please remember to write down the product serial number and article number as
required and attach your receipt to this page.
Product serial number (rating plate) *
Product artical number (rating plate) **
Purchasing date
General information
The drawers, baskets and shelves should be kept in their current position unless otherwise specified in this quick guide. The light system inside the refrigerator compartment uses LED lights, allowing for better lighting than with traditional light bulbs, as well as for very low energy consumption. Doors and lids of the refrigeration appliance should be removed before disposal in the landfill, to avoid children or animals getting trapped inside. This product contains a light source of energy efficiency class G.
Technical data
| IKEA | HUTTRA | 3 | 187 | 39 | F |
|---|---|---|---|---|---|
| Brand | Model | Freezing capacity (kg/24h) | Energy consumption (kwh/year) | Noise | |
| level (dba) | Energy class |
To download the full version visitwww.ikea.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>