VASIVO OPEN ONE Cell Phone Holder with Magnetic Wireless Charger Pad Instruction Manual
- June 5, 2024
- VASIVO
Table of Contents
VASIVO- OPEN- ONE -Cell -Phone- Holder -with -Magnetic- Wireless- Charger
-Pad
Installation Instructions
360° Cell Phone Holder with Magnetic Wireless Car Charger Pad (For Air
Vent) Installation Instruction 
-
Unpack the product to take out the air vent clip and fix it in place. Adjust the viewing angle and rotate the nut clockwise to tighten the clip.
Press the button on the clip to make it open wide. Use the clip to grip the bottom leaf of the air vent. -
Insert the USB cable into the charging port at the bottom with the indicator lighting up the clamp arms of the holder will automatically open wide for the user to put the cell phone on the magnetic pad. Then the holder will grip the phone automatically.
-
When the user needs to take out the phone, just press the button on the top of the holder, and the holder will open automatically.
Cell Phone Holder with Magnetic Wireless Car Charger Pad (For Air Vent)
Installation Instruction
- Align the cell phone holder with the suction cup and fix them in place. Rotate the nut clockwise to tighten the suction cup.
- Rotate the adjustable knob on the side to adjust the angle of the holder arm to the appropriate position.
- Rotate the adjustable knob on the bar to stretch the bar to the appropriate height.
- Place the suction cup on the gasket, and press the suction cup to make it fix firmly.
- Insert the USB cable into the charging port at the bottom with the indicator lighting up.
- The holder will automatically open wide for the user to put the cell phone on the magnetic pad. Then the holder will grip the phone automatically.
- When the user needs to take out the phone, just press the button on the top of the holder, and the holder will open automatically.
FCC Requirement
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>