JLAB JLTWS1004 True Wireless Earbuds User Guide

JLAB JLTWS1004 True Wireless Earbuds User

BLUETOOTH PAIRING

1. Remove tab and close door.
2. Red light on case indicates charge. Remove earbuds from case.
3. One earbud will blink blue/white indicating ready to pair to your device.
4. Select “JLab GO Air Pop” in your device’s Bluetooth settings to connect.

Voice prompt “Bluetooth connected” followed by blinking white lights will indicate a connection.

ADDING NEW/ADDITIONAL BLUETOOTH DEVICES

Turn OFF Bluetooth from any previously connected device. Turn ON Bluetooth from new device. Take earbuds out of the case. Earbuds will automatically enter Bluetooth Pairing. Select “JLab GO Air Pop” in device settings to connect.

BUTTON FUNCTIONS

• VOLUME DOWN: Single tap
• VOLUME UP: Single tap
• PLAY/PAUSE: Double-tap- SIRI (OS) or “OK GOOGLE” TRACK FORWARD:
• Press& hold 1+ sec (ANDROID): Double-tap
• TRACKBACK: Press &hold 1+ sec ANSWER CALL: Single tap
• HANG UP: Double-ta
• REJECT INCOMING CALL: Press & hold 1+ sec
• EQ CHANGE: Triple tap

CHARGING EARBUDS

1. Earbuds will power off when placed in the case and start charging the earbuds.
2. Earbuds will auto power on and connect to your devica when removed.

CHARGING CASE
Connect the GO Air Pop into a computer or Use 5V 1A (o less) output device.

Fitting

Try al her tips for best it and proper seal. Place the earbud in the ear canal and slightly rotate to adjust for the best fit.

VOICE PROMPTS

• “Hello”: Power ON
• “Battery Full”: 100-75%
• “Battery Medium”: 75-25%
• “Low Battery”: Less than 25% (When power decreases to 10%, “Low Battery” will play one time)
• “Goodbye”: Power OFF
• “Ready to Pair”: GO Air Pop is ready to pair to a Bluetooth device
• “Bluetooth Connected” Earbud is connected to the device

EQUALIZER MOD
S38 JLab SIGNATUR JLab C3TM signature sound with amplified vocals and ba

BALANCED
Even sound with no addition. sound enhancements 88 BASS BOoST Amplified bass and sub-bass

QUICK TIPS

The left or right earbud can be used independently for music and phone calls. Simply choose one and take out of the case to connect. Only ONE Bluetooth device can be connected at a time. Turn off Bluetooth on unwanted devices and
turn on Bluetooth on the chosen device to connect. Fully dry off earbuds before putting in the charging case to avoid any damage to the case. The earbuds are sweat/water resistant but the case is not.

TROUBLESHOOTING

Connection failure or earbuds disconnected from each other (Manual Reset)

1. Keep the earbuds in the charging case and forget “JLab GO Air Pop” from your Bluetooth
2.  Quick tap 7x on one earbud in charging case. Earbud blinks blue 4 times.
3. Quick tap 7x on another earbud in charging case. Earbud blinks blue 4 times.
4. Take both earbuds out of the charging case. One earbud will be solid white and other will blink blue/white indicating ready to pair to your device.

FCC Information

This equipment has been tested and found to comply with the limits for a Cass B digital device, pursuant to Part 15 of the FOC Rules. These Limits are designed to provide reasornable protection against harmful interference in a residential installation, Ihis equipment generates, Uses and can radiate radio frequency energy and, if not installed and usedin accordance with the instructions, may cauSe harmful interterence to radio communications. However, there is no guarantee that interference
will not ooCur in a particuar instalation, If this equpment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to corect the interferenoe by one or more of the toloing measures:

• Reorient or relocate the receiving antenna. hcrease the separation between the equipment and recelver,
• Connect the equipment into an outlet on a circuit different from that to which the recelver is connected,
• Consult the dealer or an experiernced radio/TV technician for helo. f you cannot eliminate the interference, the FCC requires that you stop using your product.
• Changes or modifications not expressly by the party responsible for compliance could void the users authority to operate the equipment.

This device comples with Part 15 of the FOC Rues, Operation is subject to the following twO conditions:  this device may not cause harmful interference, and this device must any interterence receved, ncluding interference that may cause
undesired coeration.

EU Compliance CE
PEAG LLC dba JLab hereby declares that this device is in compliance with the essential requirements and other relevant provisions of the RED directive. A copy of the EU Declaration of Conformity is avalable at
jlab.com/oomplianc PEAG, LLC dba JLab Keizersgracht 482(C/O: E,O,Dike) Unit #104 Amsterdam, 1017 EG Netherlands JLab 2281 Las Pamas Drive, Suite 101, Carlsbad, CAA 92011, USA The symbcd above indicates that this product and/or battery should not be disposed of with househokd waste. When you decide to dispose of this product and/or its battery, do so in accordance with local ewironmental laws and guidelnes.

Battery Caution & Disposal Information

Please take care of your battery, Do not; disassemble, burn, up crush or bend your battery, Improper operaticn of the bettery m  product smoke, In such an event, ventlate the area, Extinguish fames with carbon dioxide, dry-powder fire extinguisher, or co sand or mud, Take care to avoid conditions of excessive moist prolonged periods and do not immerse, Do nat expose to temp above 50 C/122°F, Charge battery fully before storage or if sto onger than three months, The operating temperature af this pm OC (32°F) to 40°C (104 F), Ambient temperature should not ex 45C (113F.

Disposal
At the end of its life, please take care to dispose of this product responsibly, Ebctronic products and batteries contain materials can be harmful to the environment, Pease do not dispose to un waste, Take your electronic waste to a designated colection or recycling facility to be recycled properly, Your local councl auth be able to tell you where your nearest facilfities are, There may b your local supermarket, JLab can help you recycle. Learn more jlab.com/recycle

Contact Us

If you’re unsatisfied with your purohase, please contact us and we’ll take care of youl You can contact our US based customer support team:

• Emal: support@jlab.com
• Phone U.S.: +1 405-445-7219 (Check hours jlab.com/hours)
• Phone U.K/EU: +44 (20) 8142 9361 (Check hours jab.com/hours)
• Visit lab,com/warranty to initiate a return or exchange,

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>