XGIMI X Roof Ceiling Bracket Instruction Manual
- June 3, 2024
- XGIMI
Table of Contents
XGIMI X Roof Ceiling Bracket
Installation Instructions
Please read the Product Instructions carefully before using this product
Thank you for purchasing the XGIMI Ceiling Bracket. For your safety and
benefit, please read the Product Instructions before using this product. XGIMI
Technology shall not be liable for any personal injury, property damage, or
other losses caused by failure to follow the directions and precautions
detailed in the Product Instructions.
About the Product Instructions (hereinafter referred to as“the
Instructions”)
The Instructions is the copyright of XGIMI Technology; Trademarks and names
mentioned in the Instructions belong to their respective rightful owners; If
any content of the Instructions is inconsistent with the actual product, the
actual product shall prevail. Any objections to any content or clause found
within the Instructions should be reported to XGIMI Technology in written form
within 7 days after the purchase; otherwise, it will be assumed that you agree
to, understand and accept all the content of the Instructions.
Product Parts List
- Tripod X1
- Base X1
- Base decorative cover X1
- Bracket rod X3
- Self-tapping screw X4
- Expansion screw X4
- Allen key X1
- Please check carefully whether the actual product components are consistent with the list. Please contact our customer service promptly if product components are missing or damaged.
- Please check carefully whether the actual product components are consistent with the list. Please contact our customer service promptly if product components are missing or damaged.
- Determine where the device will be placed on the ceiling, and use the provided expansion screws or self-tapping screws to install the base. After, install the decorative cover. (Please use self-tapping screws if your ceiling is wooden.)
- Connect the metal rods as shown below. (Choose the length of the connection according to your need. Please ensure the 10cm long metal rod with the threading hole is used. Otherwise, you won’t be able to thread any cables.)
- Install the tripod onto the metal pole. Rotate the decorative cover on the tripod to adjust the angle according to the desired projection effect. Use the Allen key to lock the screws and tighten the decorative cover after finishing the adjustment.
Installation complete
Chengdu XGIMI Technology Co., Ltd. Building A4, No. 1129 Century City Road, New and High-tech zones, Chengdu City China