LINEAR MCT-3 Megacode Three Channel Remote DNT00089 Instructions
- June 5, 2024
- LINEAR
Table of Contents
MCT-3 Megacode Three Channel Remote DNT00089
**Instructions
**
MCT-3 DNT00089 ACT-31B ACP00879 WD3 27310 Remote
To Add or Remove a Remote Control
-
Press the operator’s LEARN button. The red LEARN light will glow. The red light will stay on for about 15 seconds. A remote must be added or removed while the red LEARN light is still on.
-
Send a signal from a remote. The opener’s light and the red light will flash once if a remote was added, or the opene「’s light and the red light will flash fumes if a remote was removed.
-
Repeat Steps 1 & 2 for any additional remote controls
To Remove all Remote Controls
-
Press and hold the operator’s LEARN button for ten seconds or more.
-
Release the LEARN button. The red LEARN light will blink three times signaling that all of the remotes in the operator’s memory were erased. The red LEARN light will turn off, then turn on for 15 seconds. The remote control can be entered during this time using Step 2 above.
Testing
-
Before testing the remote control, straighten out the operator’s white antenna wire so it points up
-
Stand clear of the door, press the remote control’s button and verify that the operator starts.
PRESS THE REMOTE CONTROL.:S BUTTON AGAIN TO STOP THE DOOR MID-TRAVEL.
-
Set the open and close limits as described in the next section before any further testing.
Replacing a Remote Control’s Batteries
When the red light on the remote glows dimly or fails to light at all when the
remote is activated, the battery needs replacing.
- Open the remote’s case and remove the circuit board.
- Replace the old battery.
- Reassemble the remote.
****FCC Caution：
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>