SULONG TOYS SCY-16201 Anti Interference Reliable RC Offroad Car User Manual
- June 3, 2024
- SULONG TOYS
Table of Contents
SCY-16201 Anti Interference Reliable RC Offroad Car
User Manual
ABOUT THE RC CAR
The RC car adopts 2.4G variable speed control technology to control functions such for forward, backward, left and right turning and multiplayer competition without interference. Pull the Trigger to control the speed. The harder, the faster, and the slighter, the slower.The design such as powerful motor and antiskid tyres makes stable driving of the car possible, bringing you an ultimate experience full of speed and thrill!
1. ON/OFF Switch| 4. Rechargeable Battery| 1. ON/OFF Switch| 3. Forward/
Backward Trigger
---|---|---|---
2. Battery Compartment| 5. Battery Connector| 2. Indicator Light| 4.
Steering Wheel
3. Battery Compartment Screw| 6. Direction Fine-tuning
ACCESSORIES
PREPARATIONS
Charge the Battery for RC Car
STEPS
-
Unscrew the screws on the battery compartment in the car with a screwdriver,take out the battery for charging.
-
Connect one end of the USB charging cable to the battery connector and ensure it is correctly connected. Then insert the other end of the USB charging cable into safe power supplies with USB socket, such as PC, laptop, mobile power, or USB power socket etc.The red light turns solid on during charging and goes out when charging completes.
Full charging takes around 3 to 5 hours. -
After charging, connect the battery with the battery connector and ensure it is correctly connected.
-
Insert the battery into the battery compartment, refit the battery cover, and finally tighten the screws with a screwdriver.
NOTICE:
- Juveniles shall be accompanied and guided by their guardians to charge the product.
- It is recommended to fully charge the battery to ensure sufficient power before the first use. Please understand that the running time will be relatively shortened without prior charging for the first use due to insufficient power of the battery, which is caused by the auto discharge during transportation.
- Do not charge batteries that are inflated, leaked or damaged. Do not overcharge the battery.
- Please use the original USB charging cable from the factory. Do not use charging cables that are damaged or non-original ones.
- Keep it away from flammable materials and do not put it on the surface of conductive objects(such as carpet, wooden floor or furniture, etc.) during charging.
- Please be careful to avoid electric shock while using the electrical products.
3.2 Install the Battery for Remote Controller
STEPS
- Use a screwdriver to unscrew the screws on the battery compartment of the remote controller and open the battery cover
- Install three new 1.5V AA batteries (not included) into the battery compartment and make sure the “+” and “-”of the batteries match with those indicated inside the compartment.
- Refit the battery cover and tighten the screws.
USE 3X1.5V “AA” BATTERIES (NOT INCLUDED)
NOTICE:
- Please ensure the “+” and “2 electrodes have been correctly aligned.
- Do not mix old and new batteries.
- Do not mix different types of batteries.
3.3 Drive in Suitable Environment.
NOTICE:
- Do not use it in conditions like rains and snowstorms etc. to avoid accidents.
- Do not use it on public roads to avoid impacts on the traffic.
- Do not use it near crowded places, people or animals to avoid environmental damage or body injury.
- Do not use it in the rain or let the car run over the puddle to avoid malfunction.
- Do not use it near rivers, ponds or lakes to prevent the car from falling into the water.
DRIVE VIA REMOTE CONTROL
STEPS
MAINTENANCE
TROUBLE SHOOTING
Problems | Causes | Solutions |
---|---|---|
RC car/ remote controller out of control/ not responsive | 1.Switch not turned | |
on. | 1.Turn on the switch. | |
2.Batteries improperly installed. | 2.Ensure the positive and negative |
terminals are correctly aligned.
3.Low battery voltage.| 3.Replace the batteries of the remote controller/
Recharge the batteries for the RC car.
4.0ut of control range.| 4.Control it with in 45 meters.
5.RC car not pair with the remote controller.| 5.Power off the RC car and the
remote controller and then turn on again and pair again.
Close control range.| 1.Signal interference around.| 1.Try to drive in another
place.
2.Low battery voltage for RC car/ remote controller.| 2.Replace the batteries
of the remote controller/ Recharge the batteries for the RC car.
RC car fails to drive in a straight line.| 1.Excessive surface friction or
extremely smooth surface.| 1.Try to drive in another place.
2.Fail to activate fine-tuning function.| 2.Toggle fine-tuning switch to trim
the directions.
NOTE
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>