SULONG TOYS SL-00003 Remote Control Car Instruction Manual

SULONG TOYS SL-00003 Remote Control Car

ILLUSTRATION OF PLACEMENT OF THE UV STICKERS

IMPORTANT NOTICE

ATTENTION

• Before using the product, the guardian bear the responsibility to understand the instructions in this manual and give guidance to use

• this product in the right way. When using tools like knives to assemble this product, adult supervision is needed, and special attention should be paid to avoid personal injury.

• This product should be kept properly to prevent children from accidental ingestion.

• The removed parts shall be properly placed where is out of children’s reach of.

• Plastic bags are not toys and might cause a choking hazard. Please dispose of them properly after unboxing.

• These rubber parts may contain sharp tips. To avoid personal injury, please be careful while assembling and transporting the model.
  Only alkaline batteries or rechargeable batteries is applicable.

• Do not mix different types of batteries or old and new batteries. Depleted batteries should be removed from the model.

• The battery replacement shall be implemented under adult supervision with the two poles aligned correctly to avoid short-circuit.

• Do not charge non-rechargeable batteries. Take the rechargeable batteries from the model before charging.

• Make sure the charging process is under adult supervision. Do not charge when the batteries are damaged or leaks.
  Only use batteries of identical type or equivalent to the recommended type.

• Do not insert the wires or components into sockets. Do not connected the toy with excessive power supplies than recommended.

• Do not place the batteries near the source of fire or waters, or knock or have it exposed to the sun.

• If your skin or clothes have contacts with the battery leakage, please have it or them rinsed immediately.

• Charging the rechargeable batteries on a regular basis is conductive to their storage.

• Please use chargers that are identical or equivalent to the recommended ones for charging.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

REMOTE CONTROLLER PANELS DIAGRAM

STEP-BY-STEP ASSEMBLY INSTRUCTIONS

CAR BODY PANEL DIAGRAM

STEP-BY-STEP ASSEMBLY INSTRUCTIONS

VEHICLE DIAGRAM

STEP-BY-STEP ASSEMBLY INSTRUCTIONS

ABOUT THE REMOTE CONTROLLER

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>