TFA 30.1025 Digit Window Thermometer Instruction Manual

: June 5, 2024
: TFA

Table of Contents

Features:
Use:
MAX/MIN temperatures:
Installation:
Battery replacement:
Care and maintenance:
Disposal of the batteries
Specification:
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

30.1025 Digit Window Thermometer
Instruction Manual

VISION – Digital Window Thermometer

Features:

Clear functional design
Easy reading of the outside temperature from the inside
Maximum and minimum values with auto reset
Easy to fix, demountable for window cleaning
Weather-resistant

Use:

Open the battery compartment with a screwdriver and remove the battery insulation strip. Close the battery compartment carefully. Remove the protective films from both sides of the display. The device is now ready for operation.
For transparent packaging, the W and rain protection (see below) is already pre-assembled. To remove both protective films, first, remove the plastic plate.
The upper display shows the maximum temperature, the middle display the current temperature, and the lower display the minimum temperature.
Important note for the use: Due to the heat emission (depending on insulation) and the protected location of your window it is possible that the temperature displayed on your VISION is higher than the outdoor temperature at a free unsheltered location directly over the ground.

MAX/MIN temperatures:

There is an automatic reset of maximum temperature at 6:00 and minimum temperature at 20:00. Therefore the current time must be set.

The setting of the clock:

Press the MODE button to enter the setting Set the hours by pressing the “+” button. Hold and press the button for a fast count.
Press the MODE button again to set minutes in the same way.
To go back to normal mode press the MODE button once

Installation:

Fix the holder with the enclosed adhesive outside at the window. Please clean the window glass before. Now you can hang up and demount the thermometer very easily.

Attention:

Avoid direct sunshine: It falsifies the indicated values! Extremely high temperatures may lead to damage of the display. Permanent sunshine may bleach the liquid crystals.
To improve W and rain protection and the clearness of the display especially when it’s dark you find enclosed a plastic plate (pre-assembled in transparent packaging). We recommend the use particularly when your VISION window thermometer is located at the weather side or exposed to strong solar radiation. Simply put the plate in the provided slots behind the display.

Attention! The display is delicate! Do not pull or bend when removing the plate or demounting the thermometer.

Battery replacement:

Replace the battery when the display becomes
Remove the instrument from the Open the battery compartment by a screwdriver and remove the battery. Insert a new battery (1.5 V AAA).
Close the battery compartment
Use alkaline batteries only. Observe correct polarity

For your safety:

The product should only be used as described within this instruction.
Unauthorized repairs, modifications or changes to the product are prohibited.

Caution!
Risk of injury:

Keep this device and the battery out of reach of children.
Small parts can be swallowed by children ( under three years old).
Batteries contain harmful acids and may be hazardous if a battery is swallowed, this can lead to serious internal burns and death within two hours. If you suspect a battery could have been swallowed or otherwise caught in the body, seek medical help immediately.
Batteries must not be thrown into a fire, short-circuited, taken apart or at Risk of explosion!
Low batteries should be changed as soon as possible to prevent damage caused by
Avoid contact with skin, eyes and mucous membranes when handling leaking In case of contact, immediately rinse the affected areas with water and consult a doctor.

Care and maintenance:

Do not expose the device to extreme temperatures, vibrations, or shocks.
Clean it with soft damp Do not use solvents or scouring agents.
Remove the battery if you do not use the product for a long period of time.

Waste disposal:

This product and its packaging have been manufactured using high-grade materials and components which can be recycled and reused. This reduces waste and protects the environment. Dispose of the packaging in an environmentally friendly manner using the collection systems that have been set up.

Disposal of the electrical device

Remove non-permanently installed batteries and rechargeable batteries from the device and dispose of them separately.
This product is labeled in accordance with the EU Waste Electrical and Electronic Equipment Directive (WEEE).
This product must not be disposed of in the ordinary household waste. Asa consumer, you are required to take end-of-life devices to a designated collection point for the disposal of electrical and electronic equipment, in order to ensure environmentally-compatible disposal. The return service is free of charge. Observe the current regulations in place!

Disposal of the batteries

Batteries and rechargeable batteries must never be disposed of with household waste. They contain pollutants such as heavy metals, which can be harmful to the environment and human health if disposed of improperly, and valuable raw materials such as iron, zinc, manganese or nickel that can be recovered from waste. As a consumer, you are legally obliged to hand in used batteries and rechargeable batteries for environmentally friendly disposal at retailers or appropriate collection points in accordance with national or local regulations. The return service is free of charge. You can obtain addresses of suitable collection points from your city council or local authority.
The names for the heavy metals contained are Cd=cadmium, Hg=mercury, and Pb=lead.
Reduce the generation of waste from batteries by using batteries with a longer lifespan or suitable rechargeable batteries. Avoid littering the environment and do not leave batteries or battery-containing electrical and electronic devices lying around carelessly. The separate collection and recycling of batteries and rechargeable batteries make an important contribution to relieving the impact on the environment and avoiding health risks.

WARNING! Damage to the environment and health through incorrect disposal of the batteries!

Specification:

Measuring range:…………………………….-25`C to +70’C
Precision:………………………………….. OIC to 50t t, otherwise ±1.5°C
Resolution:……………………………………..0.1°C
Battery:………………………………………….1.5 Volt AAA
TFA Dostmann GmbH & Co.KG, Zum Ottersberg 12, 97877 Wertheim. Germany No part of this manual may be reproduced without the written consent of TFA Dostmann. The technical data are correct at the time of going to print and may change without prior notice. The latest technical data and information about this product can be found on our homepage by simply entering the product number in the search box. WWW.tfa-dostmann.de

Instruction manuals www.tfa-dostmann.de/en/service/downloads/instruction- manuals