MyWall 2265873 HL 41 MWL TV Ceiling Mount Roof Suspension Bracket Instruction Manual

: June 5, 2024
: MyWall

Table of Contents

Instructions
Documents / Resources

MyWall 2265873 HL 41 MWL TV Ceiling Mount Roof Suspension Bracket

Instructions

Before power connection, be sure that bracket and the TV installed correctly.
Keep the children away from powe r.

OK : Stop Button HL 41 ML / HL 41 MWL
RMT-02 remote control, 2x AAA battery (not included)

Reset Mode

If the TV mount can`t be adjusted to the highest position (0 degree against the ceiling) or the lowest position (max. tilting position), unplug and re- plug the power. Then press and hold the OK button for 5 seconds. Mount will retract to the highest position, that means the system has been successfully reset.

Reset the Tilt Range for Pitched Ceiling

The TV mount is 0° – 75° tilt adjustable by default for flat ceiling. Please reset the tilt range if you use as a pitched ceiling TV mount.
Step 1: Reset the system (Instructions on Reset Mode)
Step 2: Press Downward Movement, Upward Movement and OK buttons and adjust to the proper position.
Step 3: Press and hold the Memory Setting 1 button until the unit beeps once. Repeat this step 5 times. The unit will emit a long beep to indicate success. Note: Step 2, 3 should be finished in 2 minutes, or it will fail to reset.

Manual mode

In any positlon (but the minimum position against the ceiling): when manually push up the TV ceiling mount over a distance, the TV ceiling mount will automatically return back to the minimum position against the ceiling.

Coding of Remote Controller and Control Box

Step 1: When the mount is powered on, press the small button on the control box with a thin tool as shown. The unit emits a beep, indicating that the control box is on standby for program coding.
Step 2: Press the SET button on the remote control, and the control box repeatedly beeps for approximate 10 seconds indicating that the remote control is being programmed. The process will be finished automatically until you can`t hear a beep any longer.
NOTE: The TV Mount can be matched with up to 20 remote controllers. To clean up the data of all the remote controllers, press and hold the code matching button for 5 seconds then release. The unit will emits two beeps confirm the successful clean up and vice versa.

Hereby, Transmedia Kabelverbindungen GmbH declares that the suspension brackets type HL 41 ML / HL 41 MWL is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.transmedia- germany.com/download