aquilo DAEM4GRWA Air Pump User Guide
- June 5, 2024
- aquilo
Table of Contents
Quick User Guide
- Fill the tank to 1 or 2 users’ lines (for both water and ice)
- Connect air tubing from the Aquilo control unit to each air attachment on the Boots
- Connect water tubing from Aquilo control unit to each water attachment on the Boots
- Put on the Boots and zip until highest point
Upper screen
(water pump)
- The press Power button on the right corner (metal button) in order to switch on the device
- Turn on the water pump by pressing the far left button for 3 seconds, then press again to start
Set timer by either pressing + or – to increase or decrease time (standard
time is 25mins)
The pulse button will run the water pump for 2 minutes on, 30 seconds off,
repeat
**Bottom screen
(air pump)**
Press Play for Standard Pressure settings
Standard-setting: 75mmHg, 30min, and sequential compression – bottom-up(Mode
- Changing compression Modes
- Press Set button on the top left and then the + or – button on the top right. A Red Arrow will appear under the Mode (ex. M1, M2, …)
Mode 2
Uniform compression – all air channels are filled at the same time
Mode 3
Sequential compression – top to bottom
Mode 4
sequential compression: bottom up with 1 channel at a time; releasing the previous channel
Mode 5
sequential compression: bottom to top with 2 channels at a time It is also possible to select specific air channels by clicking on them (1CH, 2CH..)
Changing compression levels
-
Press the OK button below the Set button and then + or – to increase or decrease levels. A Red Arrow will appear under the mmHg
The minimum compression level is 20mm of mercury The maximum compression level is 150mm of mercury
Changing time
Press the OK button below the Set button and then + or – to increase or decrease the time
Minimum time: 20mins
Maximum time: 200mins
Press and hold the Lock button, if desired, to lock settings and prevent changes to settings -
Press the Start/Pause button at the bottom left in order to launch the compression pump