aquilo Cryo Portable Ice Bath System User Guide
- June 5, 2024
- aquilo
Table of Contents
Quick User Guide
-
Fill the tank to 1 or 2 users’ lines (for both water and ice)
-
Fit Recovery Pants around the body using included Velcro flaps
There are 3 flaps on each leg and 2 flaps for hip adjustments -
Connect tubing from Aquilo control unit to Recovery Pants
-
Plug Aquilo Control Unit into a power source using provided cable (do not substitute the power cable).
Then press Power (metal button). The Power Button will turn blue
Power on
Follow instructions to power on the water pump (on-screen)
-
Activate water pump by holding the ON button for 3 seconds
Start water pump by pressing the ON button again
A blue light (pump) starts blinking blue and indicates that the water pump is operating
If the control unit is charged, no power source is required -
If the battery level is too low, the machine will not power on without the power cable Set Time to your preference using the +/- buttons. We recommend 20 minutes
- Optional Pulse feature will allow the water pump to run for 2 minutes, off for 30 seconds, repeat
Charging the Aquilo Control Unit
Plug Aquilo Control Unit into a power source using provided cable (do not substitute the power cable).
Then press Power (metal button). The Power Button will turn blue
The Battery level lights (green) will be flashing with their battery level until full
Recommendations
After the duration of your session, wait 2-3 minutes before unplugging the
connectors from the Recovery Pants. This will allow the water to drain from
the pants back into the tank Drain tank after each session using provided
drain hole/caps on either side of the tank. Some water remaining in the tank
is okay.
Remove plastic screen protector, if desired. This is easiest to do by peeling
the plastic off the Power Button (metal)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>